Kenmore / Sears Screws, Nuts, Washers

Specs: 10 - 16 x 3/4 phillips truss head

This screw set contains the fasteners used to secure panels and components on compatible Frigidaire appliances, helping restore proper fit and reduce rattling or loose parts. Replace missing or worn screws to re-secure covers and mounts. What it does:

• Provides the correct fasteners for reattaching trim, panels, or internal components
• Restores secure mounting to reduce vibration, rattling, or loose panels
• Replaces missing or damaged screws that prevent proper assembly
• Helps ensure service repairs use the correct OEM-style hardware

• One screw set

• Use the screws only in the specified locations and quantities recommended by your service guide
• Tighten screws snugly but avoid over-torquing to prevent stripping or damage
• Disconnect power (and water, if applicable) before servicing the appliance
• If any fastener appears damaged or the fit is incorrect, stop and verify fit before completing the repair

This flat washer provides a firm, low-profile bearing surface for a fastener or shaft, helping distribute load and reduce wear on mating parts. It's a small replacement that restores proper spacing and secure assembly. What it does:

• Sits between a nut or bolt head and the mating surface to spread clamping force and prevent pull-through
• Helps maintain correct spacing and alignment of connected components
• Reduces friction and wear between rotating or tightened parts
• Can prevent loosening by protecting the mating surface from damage

• One flat washer

• Inspect mating surfaces and replace any damaged fasteners before reinstalling the washer
• Clean the area of debris or corrosion to ensure a flush fit
• Reuse fasteners only if they are undamaged; torque to the appliance manufacturer's specifications where available
• For electrical or safety-related repairs, disconnect power before starting work