Kitchenaid Refrigerator Parts

Replaced water inlet valve. Read more

Replaced icemaker and shutoff arm. Easy project. Read more

Purchased a new replacement ice maker and plugged it in - worked beautifully. The best part is I ordered it Monday afternoon and received it early Tuesday. Very pleased. Read more

Watched the Youtube video suggested. It was a piece of cake to change out the gasket. Read more

Replaced heating element and thawed out ice buildup. Read more

Replaced internal water supply line to ice maker and water reservoir line for door water dispenser. Parts arrived quickly and repair was a no-brainer thanks to the repair videos. Read more

I went online and found AppliancePartsPros.com who had the parts drawings and numbers. It wasn't immediately apparent how to get from the parts page to the shopping cart but a quick call cleared it up. All the parts I ordered showed up in a timely manner and where actually the right ones. The repair went easy because the plus parts that needed special instructions had them. My wife and I are very happy with how things turned out. Thank you David Smith Read more

Take off freezer door and tried to take off top shelf. Never got shelf off. Made it more difficult but got it replaced. Read more

Replaced entire ice maker. A couple of important points. (1) The ice maker module does not include all parts. The door flap for example is not included. So save all plastic parts from the old unit including screws. The biggest installation problem was the power cable. There was little room on the side of the ice maker for the cable and connectors to fit. Make sure the connector that mates with the refrigerator cable is seated onto the plastic housing and does not stick out or dangle out.... Read more

The video was very helpful, but my KitchenAid model required slightly more steps. Only the two screws in front held the filter housing, same as the video shows, but it has to be removed from the rear. My model did not have the wire brace, only the two front screws held the housing. Shut the water off and pull the electrical plug. Remove the two screws holding the filter housing in the front. Remove the lower panel in the rear at the bottom of the refrigerator. Remove the two screws holding the... Read more

Ordered a replacement glass shelf. It arrived 4 days after ordering. Fit like a glove. Read more

The evaporator fan had stopped working and caused the entire area around it to ice up. No air flow was getting from the freezer to the fridge. I replaced the damper control (it was rusted, not sure if it was workign or not) and the evaporator fan. It was a very quick repair once I diagnosed the problem. The most time consuming part was taking all the compartments apart to get to the affected area. Read more

Well, I took it out (it slides out) to get a good look at it,so i could ref pictures on your site..naturally I had serial/model of refrig,and thats mandatory to get the right part. It came in 2 days,,and being just the bucket, it took only a few minutes to transfer the auger assembly/cube/crusher.... into the new one, 6 screws total..Your site has excellent vids on DIY.......I HIGHLY reccomend. Whole process was'nt over 15 minutes, piece of cake....And NOW i can go back to my nightly 'scotch... Read more

Added a new shaft as the old shaft had worn down...........works perfect now. Thank you Easy fix ....no more than 10 mins. Read more

The right door on our Jenn Air French Door Refrigerator would pop open & not fully close when the left door was closed first. Called the local distributor/dealer who advised me that the magnetic door gasket probably needed replacement (cost $300.00 + for the repair) What??? Visited you web site where I noted the right door had a "closure & bushing" on the bottom of the door. Could it be this was the problem fix? Took the right door off & examined both pieces. Sure enough the bushing was... Read more

Found the part on your site, was easiest to use, ordered it and replaced it. Read more