Magic Chef Parts

• No hot or cold water

Removed old water valve and replaced it with new one. Reconnected wiring and water lines. Everything is working fine now. Read more

Bought the parts and connected same...a breeze in finding and receiving and eventually installing these parts. Read more

Replaced igniter switch harness Read more

Changed the knobs from cheap parts to oe parts from appliance parts Read more

Replaced the motor, however not the easiest to do with the older refrigerators. First I had to remove the shelf that hold the ice bin. There is a small screw midway underneath the tray. Once removed the shelf is loose but still hard to remove. There is a side panel that is slotted andonce removed the shelf can then be removed, but not knowing that it is a very odd fitting unit. Then comes the unplugging which cannot be seen so it is all by feel. Once the shelf drops down the plug is now... Read more

I installed the door latch assembly and handle. It worked fine after that. Read more

Remove unit, remove about 12 screw holding the top to the unit switch the tops reverse steps and done Read more

Found the parts I needed on the Appliance Parts Pros website. Went to my local appliance store with the pictures from the website, and they did not agree that the replacement rack roller was what I needed. I was to return with a picture of my Dishwasher upper rack to show them. This was a 30 mile round trip, that I was going to have to do again before the parts I needed would even be ordered. Came home, went back to Appliance Parts Pros website and ordered the 2 items I needed. They... Read more

Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top. Read more

• Freezer section too warm

I removed the back panel in freezer and light cover then the following: remove the rusted clips, unplug heater and replaced new heater, the thermostat defrost I unfasten, clip on replacement and connected plugs. Read more

Dismantled the door and the part was an exact replacement. Read more

My boyfriend is to do it yourself Mr. Fix-It type remind you that I am also inquisitive when it comes to building and repairing things, but not like him. He is definitely what you call a jack-of-all-trades basically self-trained. Read more

• Won't start

Checked out the video on your site on how to disassemble the ice maker. Was really easy when you know the correct sequence. Only 3 screws and it's out of the freezer. Disassembled the ice maker on my kitchen counter and replaced the ice stripper. Reassembled and installed back in my freezer. It is as good as new Read more