Maytag Washer Dispenser Parts

The Detergent Drawer is an OEM part for Whirlpool washing machines. This drawer holds and dispenses detergent, fabric softener, and bleach into the washer at the appropriate times during the wash cycle.  

Causes of a bad detergent drawer can include buildup of detergent residue, damage from overloading, or general wear and tear.

Symptoms of a bad detergent drawer include:

• Detergent not dispensing properly
• Drawer difficult to open or close
• Leaks from the detergent drawer area
• Visible cracks or damage

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This bleach dispenser for a washing machine holds liquid bleach and releases it into the tub at the appropriate point in the cycle, helping dilute bleach and protect fabrics from contact with undiluted solution. What it does:

• Holds and meters liquid bleach until the machine calls for dispensing
• Helps ensure bleach mixes with water for even, diluted distribution
• Replace if cracked, clogged, or leaking
• Common symptoms include bleach not dispensing, bleach left in the cup, leaks around the dispenser area, or bleach spots on fabrics

• 1 bleach dispenser

• Disconnect power and turn off water before servicing
• Access and mounting vary by model; follow your service manual to reach the dispenser
• Detach hoses/clamps or fasteners, transfer any reusable hardware, and seat the new dispenser fully
• Reconnect, then run a test fill/rinse to check for proper dispensing and leaks

This dishwasher detergent dispenser stores detergent and releases it at the correct time in the cycle for consistent cleaning results. Replacing a worn dispenser restores reliable dosing so each wash performs as designed. What it does:

• Holds detergent and keeps it contained until dispensing
• Opens the detergent cup door at the programmed time in the cycle
• Directs detergent into the wash stream for even distribution
• Helps prevent poor cleaning caused by early loss or failure to dispense

• 1 detergent dispenser assembly

• Disconnect power and turn off water supply before servicing
• Remove the inner door panel to access the dispenser; support wiring and insulation as you work
• Release mounting tabs/screws, transfer the wiring connector, seat the new dispenser evenly, and tighten fasteners uniformly
• Run a quick cycle to check for leaks

This bleach dispenser stores liquid chlorine bleach and automatically dilutes and releases it at the correct point in the wash cycle. Replacing a cracked or clogged dispenser helps stop leaks, protect fabrics, and restore consistent bleaching performance.

• Holds bleach and siphons it into the tub at the proper time in the cycle
• Helps prevent undiluted bleach from contacting fabrics early
• Direct replacement for a dispenser that is cracked, warped, or clogged
• Address symptoms such as bleach remaining in the cup, dispensing too soon, leaks near the dispenser area, or fabric spotting

• Disconnect power and turn off water before servicing
• Access the dispenser through the top/console area; remove fasteners and detach connected hose(s)
• Transfer any hoses, clamps, and mounting hardware from the original part; ensure all connections are fully seated to prevent leaks
• Run a test/rinse cycle to check for leaks

This door-mounted dispenser stores detergent and rinse aid and releases them at the right time in the cycle to help deliver clean, spot-free dishes. Replace a broken, leaking, or jammed dispenser to restore proper detergent release.

• Holds detergent and rinse aid and dispenses them during the wash cycle
• Supports consistent cleaning performance by timing chemical release
• Detergent cup won't latch or open
• Rinse aid doesn't dispense or leaks from the dispenser
• Detergent remains in the cup after the cycle

• Disconnect power and turn off the water supply before servicing
• Remove the inner door panel to access the dispenser
• Disconnect the wire harness, release locking tabs/fasteners, and install the new unit flush to the door
• Clean the sealing surface; tighten fasteners evenly and run a test cycle to check for leaks and proper dispensing

Color: White
 

The Dispenser is an OEM part for Whirlpool washing machines. It holds and dispenses detergent for each wash load through the drawers located on the washer's console panel. 

Symptoms of a bad dispenser include:

• Improper or incomplete dispensing of detergent
• Detergent residue accumulated inside the dispenser 
• Drawers not opening or closing as intended

Causes of a dispenser failure can be due to worn components, mineral buildup interfering with mechanics, or damage from moisture exposure over time. 

Replacing with a new OEM dispenser restores optimal detergent delivery for every cycle. This ensures clothes are fully cleaned and rinsed without risk of detergent residue.  

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This is the siphon insert for the washer dispenser's bleach and softener compartments. It restores proper siphoning so additives empty at the right time and helps reduce standing water or residue in the drawer.

• Creates the siphon action that draws bleach and fabric softener from their cups during the rinse cycle
• Promotes complete dispensing and consistent rinse performance
• Helps minimize leftover liquid and residue buildup in the dispenser
• Typical symptoms include bleach or softener remaining after the cycle, standing water in the cups, or weak/irregular dispensing

• Disconnect power and turn off water before servicing
• Remove the dispenser drawer; lift out the old siphon from the bleach/softener cup
• Clean any debris in the cup; firmly seat the new siphon, aligned per the cup markings
• Reinstall the drawer and run a rinse cycle to verify proper draw and no leaks

Color: White

The Dispenser Drawer Assembly is an OEM component specifically designed for Whirlpool washers. It houses detergent and fabric softener during cycles.

Causes of a faulty assembly can include warping of the plastic base from heat and chemicals over many loads. Small cracks may develop in the detergent trays.  

Symptoms of a bad dispenser drawer assembly include: 

• Leaks from cracked or misaligned drawers polluting washer interiors  
• Difficulty closing or securing the assembly properly
• Premature deterioration inhibiting reliable cycles 

This OEM Whirlpool part is compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore washer models.

This replacement dispenser drawer restores smooth operation and proper dispensing of detergent, bleach, and fabric softener in your washer. It helps prevent leaks and residue when the original drawer is cracked, warped, or difficult to open and close. What it does:

• Holds and meters detergent, bleach, and fabric softener into the wash at the correct time
• Helps ensure additives mix with water and flow into the tub, not onto the cabinet front
• Direct replacement for drawers with broken handles, cracks, or swelling
• Common symptoms: leaking at the drawer area, poor dispensing, leftover detergent, or a stuck drawer

• Includes: 1 dispenser drawer assembly

• Disconnect power and turn off water before servicing
• Pull the drawer out fully and depress the release tab to remove
• Transfer any removable siphon caps or inserts from the old drawer
• Clean the dispenser housing channels, then slide in the new drawer and run a test cycle to check for leaks

One piece. Works on most Maytag washers. Color: white. It measures about 5 inches in diameter, and 5-1/2 inches high.

The Drawer is an OEM part for Whirlpool washers. It is a convenient part that holds and dispenses detergent and fabric softener during the wash cycle. This dispenser drawer ensures proper distribution of laundry soaps, allowing for effective cleaning and fabric care. It features compartments for different types of detergents, making it easy to add the right amount of each product.

Symptoms of a faulty dispenser drawer include:

• Leaking or dripping from the drawer area
• Difficulty in opening or closing the drawer
• Improper or inconsistent dispensing of detergents

A bad dispenser drawer can occur due to regular use, buildup of residue or clogs, or accidental damage. If you notice issues such as leaks, difficulty in opening or closing the drawer, or improper dispensing of detergents, it may be time to replace the dispenser drawer.

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.
 

The Dispenser Drawer Handle is an OEM part for Whirlpool washers. It provides a convenient grip for opening and closing the dispenser drawer. It allows you to access the detergent, fabric softener, and bleach compartments within the dispenser drawer.

A bad dispenser drawer handle can occur due to wear and tear, accidental damage, or excessive force when operating the handle. If you notice symptoms such as a loose or broken handle, difficulty in opening or closing the dispenser drawer, or the handle not staying securely in place, it may be time to replace this part.

Symptoms of a bad dispenser drawer handle include:

• Loose or broken handle
• Difficulty in opening or closing the dispenser drawer
• Handle not staying securely in place

Restore your washer's dispenser drawer by replacing the faulty or damaged handle with this genuine OEM part.

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This is the pull-out dispenser drawer assembly for a washer. It holds and channels laundry products into the dispenser housing so each additive is released at the right time, restoring smooth operation and proper dispensing. What it does:

• Holds detergent and additives and directs them into the wash at the correct stage
• Restores smooth open/close action of a worn or broken drawer
• Helps resolve issues like detergent remaining in the drawer after a cycle
• Addresses leaks or drips from a cracked or warped dispenser drawer

• 1 dispenser drawer assembly

• Unplug the washer and turn off water supply before servicing
• Pull the old drawer out; depress the locking tab(s) to remove
• Transfer any reusable inserts/caps from the original drawer if applicable
• Slide the new drawer into the rails until it clicks; run a quick cycle to check for proper dispensing and leaks

The Divider is an OEM part for Whirlpool washers. It fits within the dispenser drawer, creating separate compartments for different laundry products such as detergent, fabric softener, and bleach. It prevents mixing and allows for convenient dispensing during each wash cycle.

A bad dispenser drawer divider can occur due to wear and tear over time or accidental damage. If you notice symptoms such as a loose or broken divider, difficulty in separating the compartments, or improper dispensing of laundry products, it may be time to replace this part.

Symptoms of a bad dispenser drawer divider include:

• Loose or broken divider
• Difficulty in separating the compartments
• Improper dispensing of laundry products

Restore your Whirlpool washer's dispenser drawer by replacing the faulty or damaged divider with this genuine OEM part.

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.