Microwave Bumper, Bushing, Grommet Parts

This push-type plastic rivet is a small fastening clip that secures trim, panels and lightweight components on appliances. It replaces worn or broken rivets to restore a snug fit and reduce rattles or loose trim. What it does:

• Secures interior or exterior trim, panels and access covers
• Holds wiring harnesses or insulation in place where a low-profile fastener is required
• Replaces missing or damaged rivets that cause loose panels or vibration noise
• Simple push-in design creates a firm hold without screws or adhesives

• Disconnect power to the appliance before working on panels or wiring
• Push the rivet stem into the hole until it snaps; remove by prying out the center pin or using pliers
• Use the same style and size rivet as the original to ensure proper fit and retention
• Protect surrounding surfaces from tools and work deliberately to avoid damage

This snap-in plug button is a small decorative cap that covers mounting holes and finishes appliance control panels and trim. It restores a clean appearance and keeps fasteners protected from dirt and moisture. What it does:

• Covers exposed screw holes on control panels, frames or trim to improve appearance
• Helps prevent dirt, grime and moisture from contacting underlying fasteners
• Replaces missing, cracked or worn caps that make panels look incomplete
• Fits into a matching hole and snaps into place for a secure, low-profile finish

• No special tools usually required; press firmly into hole until fully seated
• Check orientation and hole size before installing to ensure proper fit
• If replacing a damaged button, remove any debris or old adhesive from hole
• Disconnect power or follow appliance safety steps if working near electrical components or controls

Hook spacer for electric ranges, ovens, and microwaves. Replaces worn, cracked, or missing spacers. Maintains proper spacing and alignment.