Refrigerator Cap Or Cover

White plastic corner cover cap for refrigerators. Replaces cracked, broken, or missing corner trim pieces. Snaps into place on cabinet corners.

Plastic cover that conceals the top door hinge on your refrigerator. Replaces cracked, broken, or missing hinge covers for a clean finished look.

Plastic cover panel that mounts on the back of the machine compartment. Replace if cracked, broken, or insulation pad is damaged or missing.

Left-hand rail end cap for refrigerator drawer slides. Replaces cracked, broken, or missing caps on drawer rail ends. Secures and protects rail edges.

Replacement access panel cover for refrigerators. Shields internal wiring and components while restoring exterior appearance. Order if cracked or missing.

Replacement hinge cover cap for refrigerator door. Restores finished appearance after door reversal or replaces cracked, broken, or missing covers.

Replace your refrigerator's damaged or missing cover cap. This protective cover installs over internal components to restore a finished appearance.

Protective cover for refrigerator control console. Shields control panel from moisture, dust, and damage. Replace if cracked, broken, or missing.

A single replacement cap handle screw that secures the decorative handle cap to the appliance door, restoring a snug fit and preventing the cap from shifting or falling off. Fits the factory handle cap design. What it does:

• Secures the handle cap to the door handle assembly so the cap stays aligned and tight.
• Fixes common symptoms like a loose or rattling handle cap or a cap that shifts when the door is opened.
• Replaces missing or worn screw hardware to restore original fit and appearance.
• Small OEM-style screw sized for the handle cap mounting location.

• One cap handle screw (black), matching the original hardware.

• Use the correct screwdriver or bit to avoid stripping the screw head.
• Hand-start the screw to ensure proper threading; do not overtighten.
• No special tools or electrical disconnection typically required, but follow appliance-specific service guidance.

Black chevron-style top trim cap for refrigerator upper control area. Replace cracked, chipped, or faded trim to restore front appearance and finish.

This white cover hinge replaces a worn or broken hinge that supports and pivots the appliance cover, restoring proper alignment and smooth opening/closing for the lid. Designed as a direct-fit replacement where specified. What it does:

• Provides a secure pivot point so the cover or lid opens and closes smoothly
• Keeps the cover aligned to prevent sagging, rubbing, or binding
• Restores a proper seal/closure when hinge wear causes gaps or misalignment
• Helps eliminate rattling or excess play caused by a damaged hinge

• Disconnect power (and water if applicable) before starting any repair.
• Handle the lid/cover carefully during removal to avoid dropping or injury.
• Basic hand tools are typically required; follow your model's service diagram for location and fastener details.
• Replace with the same OEM part number to ensure fit.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.

Protective cover cap for refrigerator temperature sensor. Snaps into place to shield sensor from damage. Replace if cracked, broken, or missing.

White plastic cover cap that conceals mullion screws in your refrigerator. Replaces cracked, broken, or missing screw covers for a finished appearance.

White plastic end cap for refrigerator front grille assembly. Replaces missing, cracked, or broken grille caps. Snaps onto grille edge for clean finish.