General Electric Refrigerator Cap Or Cover

Ice dispenser not working or crushed ice won't dispense? This crusher cover protects the ice crushing mechanism. Easy DIY repair with step-by-step video.

Ice dispenser only making crushed ice instead of cubes? This solenoid valve kit fixes the cube/crushed ice selector. Easy DIY repair with video guide.

This evaporator fan motor dust cap is an authentic OEM replacement part found on refrigerator and freezer fan motors. This dust cap prevents the fan motor bearing and housing from being damaged by dirt and debris. If the dust cap is cracked or broken, the fan may make loud squealing noises. If the dust cap is not removed and replaced, the fan could stop working and ultimately cause the refrigerator's temperature to be affected. To start, disconnect the power and water to the refrigerator. Remove food from the freezer so that the back panel of the freezer can be accessed to reach the fan. Remove the ice maker and set it outside the freezer. Disconnect the fan and take it out of the freezer to expose the fan's shaft and the dust cover. Pry the dust cover off and install the new one. Replace the fan and cover. Reconnect the wires and reinstall the icemaker. Put the food back in the freezer. Reconnect the power and water.The evaporator fan motor dust cap is a white plastic part that is sold individually. This dust cover is made for use in refrigerators manufactured by General Electric, Hotpoint, and Kenmore.

Shields the ice bucket and maintains insulation. Replace if cracked, broken, or damaged. Installs on the dispenser assembly with two screws.

Protective grille cover that mounts over the temperature sensor in your refrigerator. Replace if cracked, broken, or missing to properly shield the sensor.

White rear motor cover for refrigerator. Shields motor and fan area at back of compartment. Replace if cracked, broken, or missing to protect components.

Replaces the water filter in your refrigerator to bypass filtration. Installs in the filter housing to maintain water flow when a filter isn't needed.

Replaces a cracked, broken, or missing evaporator door flap in your refrigerator. Controls airflow from the evaporator to maintain stable temperatures.

Replaces the evaporator cover and fan assembly forming the back wall of your refrigerator's fresh food compartment. Needed when cover is cracked or damaged.

Replaces a cracked or broken freezer tower bottom cover that mounts beneath the evaporator assembly. Directs airflow and protects internal components.

Black hinge cover for side-by-side refrigerators. Replaces cracked, broken, or missing covers where the hinge mounts to restore proper fit and appearance.

Houses and protects the evaporator coil in your refrigerator. Replace this cover if cracked, broken, or missing to restore proper airflow and drainage.

Plastic housing trim that protects the evaporator coil in your freezer compartment. Replace if your cover is cracked, broken, worn, or missing.

This grille sensor is the temperature-sensing probe that monitors heat in the appliance grille area to help controls regulate cooking temperature and safety features. It provides accurate feedback so the oven or grill can maintain set temperatures. What it does:

• Senses temperature in the grille/grill area and sends readings to the control board
• Helps the appliance maintain consistent cooking or broiling temperatures
• Can cause temperature-related errors or inconsistent heating when failed
• Common symptom: oven or broil function runs too hot, too cool, or shows error codes related to temperature sensing

• One grille sensor

• Disconnect power to the appliance before any service to avoid shock or injury
• Handle the sensor carefully; avoid bending or contaminating the sensing tip
• Route and secure the sensor wiring as OEM designed to prevent heat or pinch damage

Allows water dispenser and ice maker to operate without a filter installed. Replace when damaged or missing to restore water flow. Verify fit by model.

White hinge that secures and supports the refrigerator access cover. Replace if your hinge is cracked, broken, or causing the cover to sag or rattle.