Samsung Heating Element Parts

Watched video. Took dryer apart to get to heating element and sensors. In process found alot of lint had escaped into inner dryer and had a thick coating over heating element. I cleaned out most lint and pulled apart lint trap on front and cleaned out as much accumulated lint as possible. I then removed the heating element (very simple, three screws in a support bracket) and found it was broke in one spot.(wire - element severed). I believe the heavy lint build up on elements caused lint to... Read more

• Too hot
• Takes too long to dry
• Doesn't shut off
• tripping breaker

This has been posted on my Facebook (but can't tag AppliancePartsPros) titled "As My Husband Slept!" =( Each dash represents a caption in each post. - Nice try taking a few days off! Your vacation days, or hours, are numbered ?? - Step 1: Removed 2 screws from the back. So far so good! - (after removing the top of the dryer) Wow! I'm so proud of myself ????? - (after the front panel was removed) Step 2: Remove the front panel as instructed by the guy on the video ?? ... I think I'm going to be... Read more

• Little to no heat when baking
• Oven not heating evenly
• Element will not heat
• Oven is too hot

I finally found the right serial number and found the part at Appliance Parts Pros. I was skeptical that they would send the element that had the correct rear brace fixture. when it came 2 days later i opened the box the Part was correct and it took about 15 minutes to replace since there are only two screws. My oven works fine now. THX Read more

• Too hot

We watched the Video from Appliance Parts Pros of how to repair our dryer and literally had it fixed in about the same amount of time as it took to watch the video. Taking the dryer apart is typically what would scare one away from a self repair...but it was explained in detail and actually was super easy to fix. What a wonderful company!! Self fixed and saved us from having to wait for a repair man and we didn't have any repair bill....except for the part...but even that was at a very... Read more

• Element will not heat
• Won't start

Turned off power supply. Removed two screws (near the oven door) holding the ceramic top. Slid the top forward, disengaged the two power supply cables, and removed one ground wire. Removed range top, and put on a flat surface. Unclamped two power supply wires, one ground wire and one thermocouple wire from the element. Unscrewed the bracket from the element, and remove the element from the range top. Remove the two clamps from the old element, and put them on the new element at the same... Read more

• Won't start
• No heat

Unplugged range, removed back panel. Loosened plug block from range, unhooked wires from existing element, then sliced through insulation between element ends with sharp knife. Removed screws holding element ends then removed element. Inserted new element, screwed it in place, connected wires and replaced plug block. Vacuumed up fiberglass insulation dust and replaced back panel. Replaced plug then tested. Read more

• Little to no heat when broiling

I had the choice of spending $2K on another double oven stove or $60 on two elements. (I felt more secure about replacing both bake and broil elements just in case the fire had damaged the bake element) It was an easy decision and quick replacement! Power was already off to the stove so I cleaned up the fire retardent mess. I even found easy instructions dismantling the oven door in order to clean the powder residue from between the glass. I then removed the rack and remaining old elements. I... Read more

I replaced the two affected burners, and the problem was solved. Read more

• Too hot
• tripping breaker

I found the assembly with heater element, thermostat, and the thermal fuse already assembled (cheaper than finding what part was bad and ordering that one part). unplugged dryer, pulled it out and removed the dryer exhaust tube, the top and front. The harness was a little short so I wasnt able to pull the whole heater assembly out before disconnecting. BEFORE disconnecting I took a picture so that if my brain forgot what wires went were!!!! put the dryer back together and put a load that just... Read more

By ordering the requested part you sent me. Read more

Removed the top of the range after unplugging it, removed the brace holding the element, replaced the element. Total of 20 minutes spent. Read more

Simple replacement of the heating element. Found multiple videos on youtube that show how to to do this repair. The cooktop is easily opened by removing 3 screws, but I recommend having a second set of hands when performing the repair because you will have to hold up the glass stove top and unscrew the components. The heating element is attached to a bracket that comes off easy as well. Also have to detach 5 wires that mate by sliding together. We took a picture before removing to make... Read more

• Little to no heat when broiling

Ordered a new one and replaced it myself. Read more

Replaced it. Read more

Used washer, gasket puffed up. No leak Read more