Whirlpool Panel Parts

This is the front-facing outer door panel for a trash compactor, featuring a stainless steel finish. It serves as the visible exterior surface of the compactor drawer, providing a clean and finished appearance. Replace this panel if it is dented, scratched, rusted, or otherwise cosmetically damaged.

This is the stainless steel outer panel that attaches to the front of the trash compactor drawer, providing the visible exterior finish. It serves as the decorative and protective face of the compactor door. Replace this panel if it is dented, scratched, rusted, or if you are updating the appearance of your trash compactor to match other stainless appliances.

This is a stainless steel outer panel that attaches to the front of the trash compactor drawer. It provides the visible exterior finish and protects the inner drawer mechanism. Replace this panel if it is dented, scratched, corroded, or if you are updating the appearance of your trash compactor.

Outer door panel for dishwashers. Installs on the front of the dishwasher door. Replace if scratched, dented, or to change color finishes.

This side compartment is a direct-fit door bin that restores storage on the refrigerator door, keeping bottles and small items secure and organized. Durable molded plastic replaces cracked or missing bins for reliable everyday use. What it does:

• Replaces a cracked, broken or missing door bin to restore storage capacity and organization
• Holds bottles, condiments and small containers along the inside of the refrigerator door
• Prevents items from falling when the door opens and closes
• Matches the factory shelf design for correct fit and alignment

• High-level snap-in/screw-in replacement; remove existing bin then install new bin until it seats
• Disconnect power only if removal requires working near electrical components; otherwise power disconnection is not typically needed
• Handle carefully to avoid damage to adjacent door liners or gaskets

This stainless container panel replaces a damaged or worn front for the refrigerator's storage container, restoring the compartment's appearance and helping the drawer close cleanly. It matches OEM fit and finish for a factory look. What it does:

• Replaces a scratched, dented, or corroded container/front panel
• Restores the drawer/container appearance and front edge alignment
• Helps the drawer seal and slide as intended when the front is intact
• Fits into the existing container assembly and uses factory mounting points

• One stainless container panel

• Requires basic disassembly of the container/drawer; keep fasteners and clips organized
• Inspect mating edges and clips for damage; replace any broken hardware separately
• Disconnect power only if working near electrical components; follow appliance-specific service manual