Thermador Parts

Left-side hinge bracket for range oven doors. Secures the door hinge to the frame. Replace if cracked, bent, or if door alignment is compromised.

This side-trim gasket seals the edge of the appliance door/trim to help maintain a clean fit and reduce rattling or light air leakage. It restores the door edge seal for a neater appearance and improved closing performance. What it does:

• Seals the door side trim to help reduce noise and prevent light air or moisture intrusion
• Helps maintain proper alignment and fit of the door trim for smooth opening and closing
• Replaces worn, torn or compressed trim gasket that can cause rubbing or gaps
• Supports overall door aesthetics by restoring a continuous seal line

• One side-trim gasket

• Basic trim removal may be required
• Inspect mating surfaces and remove old adhesive or debris before installing the new gasket
• Use gentle pressure to seat the gasket; avoid stretching or over-tensioning
• Disconnect power to the appliance before doing any service that exposes electrical components

Fix a non-working oven buzzer or timer with this relay switch. Controls timer alert functions in wall ovens. Direct replacement part for common timer issues.

This switch assembly replaces a faulty E34 - 19HV switch to restore proper electrical control in the appliance. It provides the same fit and function as the original to help re-enable the affected control circuit safely. What it does:

• Acts as the electrical switch that completes or breaks a circuit when engaged
• Restores normal operation when a failed switch causes intermittent or no response
• Commonly associated with control failures, unresponsive buttons, or power-related symptoms
• Matches OEM form and mounting to fit into the original switch location

• Always disconnect power to the appliance before servicing
• Handle wiring and connectors carefully; note wire locations or take a photo before removal

Fix a dishwasher door that won't stay closed or latch properly with this door latch strike. Simple repair for loose or misaligned door latches.

If your range burner won't heat properly or stays on continuously, the infinite switch may need replacement. This control regulates heat levels.

This is a thermal fuse used in a range vent hood to protect the electrical circuit from overheating. It acts as a safety device that interrupts power if temperatures exceed safe limits. Replace this fuse if the vent hood suddenly stops working or loses power without any other visible electrical issues.

This fan blade replaces a damaged or worn blower blade to restore proper airflow and reduce noise. It helps the appliance circulate air efficiently so cooling and ventilation perform as intended. What it does:

• Moves air across the evaporator/heatsink or within the appliance cabinet to support cooling and ventilation
• Restores full airflow when the original blade is cracked, warped, or missing
• Helps reduce rubbing, vibration, and unusual fan noise caused by damaged blades
• Prevents motor strain that can occur when an imbalanced or broken blade is used

• Disconnect power to the appliance before beginning any repair
• Handle the blade carefully to avoid bending the impeller fins
• Inspect the motor shaft, set screw, and mounting hardware; replace any damaged fasteners

Cooktop won't power on or has loose electrical connections? This terminal block mounting clip secures wiring connections. Simple DIY repair.

Replacement tension spring for ovens and ranges. Restores proper tension to mechanisms when the original spring becomes worn, stretched, or broken.

Replacement mounting nut for cooktops, ranges, and wall ovens. Secures components and panels. Needed when original is stripped, lost, or damaged.

Rubber grommet for electric cooktops. Installs around wiring or components to protect from vibration and wear. Replace if cracked, missing, or worn.