Thermador Parts

This is an overflow drip tray designed to catch liquid spills and boil-overs inside the range or oven cavity, preventing them from reaching internal components. It sits beneath the cooking area and collects excess moisture or grease. Replace this tray if it is cracked, warped, corroded, or no longer sitting flat, which could allow liquids to leak onto electrical parts below.

Fix a loud humming or buzzing noise from your wall oven control panel. This low-voltage transformer powers the control board and related circuits.

This is a heating element located at the bottom of the oven cavity, responsible for producing heat during baking cycles. It is a looped metal rod that glows red when energized. Replace this element if your oven is not reaching the set temperature, heats unevenly, or the element shows visible damage such as cracks, blistering, or burn-through spots.

If your cooktop burner won't heat or heats unevenly, the heating element may need replacement. This part restores proper cooking temperature control.

Replace a failed transformer cooling fan motor causing overheating issues. Circulates air to keep electrical components cool and maintain reliable operation.

Griddle cover for electric cooktops and ranges. Replaces cracked, broken, or missing covers. Protects griddle surface when not in use. Handle sold separately.

Protects beneath your range from heat and spills. Replace if cracked, warped, or missing. Installs under cooktop to shield components and simplify cleanup.

Replacement grease tray cover for ranges and cooktops. Covers the grease collection area to contain drips and spills. Needed when original is cracked or missing.

Replace your gas range's front handle assembly. Installs on the oven door or control panel. Order a new handle if yours is cracked, broken, or missing.

This pressure regulator controls and stabilizes incoming water pressure to the appliance, helping maintain consistent operation and protect internal valves and seals. Fits systems that use a 3/4 inch inlet regulator. What it does:

• Reduces high incoming water pressure to a safe, steady level for the appliance
• Prevents pressure-related leaks, valve chatter, and premature wear on seals
• Helps maintain consistent water flow for reliable cycles and operation
• Commonly replaced when irregular pressure, humming valves, or water leaks occur

• One pressure regulator (3/4 in.)

• Turn off water supply and power to the appliance before starting; relieve system pressure first
• Inspect connection fittings and seals; use appropriate thread sealant if required by the OEM
• Tighten to manufacturer torque recommendations and check for leaks after restoring water

Replace your cooktop drip pan if cracked, rusted, or stained. This pan sits beneath the burner to catch spills and protect the cooktop surface.

A small flat mounting washer that secures fasteners and provides a stable spacer for assemblies. Replaces worn or missing washers to restore proper part alignment and prevent movement. What it does:

• Acts as a flat spacer under a nut or bolt to distribute load and prevent loosening
• Keeps components aligned and properly spaced to reduce wear
• Helps stop rubbing or metal-on-metal contact that can cause noise or damage
• Commonly needed when fasteners are loose, panels shift, or assemblies wobble

• One flat mounting washer

• Shut off power to the appliance before beginning any service
• Remove any panels or components necessary to access the fastener; use hand tools appropriate for the fastener type
• Replace the washer with the same orientation and retighten the fastener to avoid over-torquing

Inner door panel for electric wall ovens and ranges. Replaces cracked, damaged, or discolored interior door trim. Installs on the inside of the oven door.