Wall Oven Control Board

Replaced front panel and motherboard Read more

Disconnected the power, removed back cover, removed old part and installed new one. I took a picture of the old part and wiring before disassembly. Easy repair, it's the second time the ECU has gone bad. Read more

Replaced the whole unit. Read more

Symptoms varied: oven not starting; oven preheats OK but after you open the door to put in food and close it, the oven showed temp OK, didn't turn on, and heat would drop to nothing over time; other times, it would begin preheating then start beeping and showing the temperature setting, then an 'ERR' and die. Would not start unless I shut off the circuit breaker, then turn it back on. At first i replaced the temp probe, which worked once then all the above began again. Next I replaced the... Read more

The display of the control worked, so one might not question it but there is nothing else that would simply shutdown while heating. This part came faster than a 'technician' and 5 sheet metal screws and 4 mounting screws later, the new unit was installed. The only delay was the waiting for the oven to reach full temp to verify that it was working - it is. The parts places try to sell a new membrane panel ( adhered display cover (numbers and labels) for these but the old one can be removed... Read more

Found online how to test for issue removed upper back panel with nut driver tested heating elements, temp sensor and controller came down to controller for oven, ordered part standard delivery was at my home in a day and a half WOW, unplugged from wall removed all electrical connectors to controller 4 screws then removed the touch pad from the old controller reinstalled pad on new controller then reinstalled controller and back panel plugged back in to wall. HERE IS THE KICKER IT WORKS BETTER... Read more

New timer! Read more

Removed the screws that hold the oven and microwave in the cabinet and slid the whole unit out 4 inches, and removed 2 screws on each side of the oven that hold the screen in. The entire front panel can then be removed. Used a very small flat screwdriver to unplug the plugs off the control board so the clips wouldnt break. Some of the plugs are labeled where they should go, but it would help to mark where they go just in case. Installed new panel in reverse order, easier than expected. Read more

Replaced the oven control. Read more

Replaced the control/clock Read more

Purchased a replacement control panel Read more