Whirlpool Cooktop Parts

First I watched the repair video, and then was successful in changing out two of the Ignitor's on the surface Burners, it worked great ! Read more

Replaced igniter under oven floor panel. Read more

Replace with a new knob. Read more

• Little to no heat when broiling

Cut off power ,inside I remove the two back screws, remove the two front screws with hangers. Pull element out, clip wires so they don't fall back in holes with clothes pins. worked good. But wire connection to the broiler was to large, had to replace connectors, wire fell in hole, had to pull wall oven out and remove back panel. I then mounted the new element to oven. Replaced connectors ,connected connectors, closed back panel, put oven in place ,connected power lines. Turned power on. Works... Read more

I immediately turned to Appliance Parts Pros and got the best price for 4 new burners and finding parts for my stove top model is a challenge due to its age. My stove top looks new again! Plus, they were delivered ahead of schedule! Thank you!!! Read more

Ordered a new burner cap. Read more

Found the parts on AppliancePartsPros.com. Very easy, found the right parts. Read more

I ordered the brioler pan for my new stove from y'all it was a little small but that's the part number in the book that I got with the stoveyall did a great job fast shipping just what I ordered will by from again thanks Read more

• Door won't open or close

The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more

• Won't start

I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more

Appliance Parts Pros was the only place that gave me options that saved me money. I will definitely use them again. Then again I was only replacing burner covers on a used gas stove we bought. The hardest part of the job was opening the package. Read more

• Gas igniter glows, but will not light

Everything works great, but my Jenn-Air stove is more than 15 years old and really needed a face lift. To replace it will cost about $3000.00 to replace, to replace missing and old parts around $500.00. Thankfully Appliance Parts Pros had all the parts I needed to make my stove look as good as it works. Read more

Replaced both hinges. Easiest repair I’ve done on this unit. Took less than 20 minutes from start to finish. Read more

Replaced the igniter. Read more