Whirlpool Cooktop Parts

Tested the High Voltage Capacitor which showing no capacitance and no resistance. Replaced it together with the diode and the line fuse no longer blew and the microwave is back in service. Read more

• Door won't open after self cleaning cycle

Based on information found at AppliancePartsPros, I determined that the it was most likely the thermostat (thermal fuse). I removed the rear panel and tested the fuse for continuity and it was bad. I used a jumper wire to bypass the fuse and plugged the range back in. The panel turned on and the oven unlocked. I then removed the thermostat and looked up the replacement part and ordered. Read more

• Won't start

Replaced pilot and thermocouple. ..pilot flame was weak ...wasn't heating thermocouple enough to power the valve Read more

• Gas igniter glows, but will not light

I ordered replacement parts to convert the side to individual burners. Read more

Check the power cord connection to the stove and found burned cable due to loose connection. Replaced the terminal and the nuts and installed a new power cord. Read more

You found the parts we need and we installed them. The sales person was excellent. Read more

Looked at YouTube on how to replace burner. Marked wires on each fitting with different color marker and took Ipad photo of underside while my wife held range top up. We had shut off range double breaker in basement. I took part to a local appliance parts house nd they ordered prt which they did not have in stock. Estimate 3days. I called on 3rd day, back ordered, maybe ship,on the 7th day. Called 7th day, maybe two more weeks. Got online, on Fri. Afternoon, you had part, shipped it that... Read more

I removed the screws inside the oven door and the retainer rings holding the handle onto the glass. I then replaced the handle put on new retainer rings and used the new screws provided and re-attached the handle and glass to the door. Total fix time 10 minutes. I was impressed by the quick delivery of my new handle and the fact that they sent new hardware as well. My oven was only down for three and a half days , only because it happened on the weekend. Read more

It's one of the easiest jobs in the world. It take longer to unwrap the parts than to install them. Looks great...works great. Easy, Done. Read more

Easy. Pulled the two screws that hold the top in place. Then lift the top and slide it forward 4 inches. Reach in and disconnect the two wiring harnesses (Squeeze the sides to release). Lift the entire top off and place it upside down on the table. Remove the four screws that hold the metal panel to the top. Flip this panel upside down. From under the panel and release the three clips that hold the element in place. ***YOU NEED TO SAVE THESE CLIPS**** they do not come with the new... Read more

I replaced the hinges, which involved removing the door by opening it all the way, inserting a small allen wrench into the locking pin hole on each of the two hinges, partially closing the door and pulling it toward me. I then laid the door stainless steel face up on a table, removed the 8 screws from the edge and pulled the bottom of the face up and toward me. The hinges lie loose in their compartments, so it's easy to pluck them out and drop the new ones in. To retrieve my allen wrenches... Read more

I found the model number on the stove and ordered a replacement. It arrived in two days. I replaced the old one and it works great. Read more

• Door won't close

This oven was a Kenmore model #66595822003. I replaced both spring hinges. This oven was a white oven so it took the MFG# WP8053807 hinge (order two of them). They are the same hinge. No left or right. To get the door off the oven, open the door all the way open, I installed pins (preferably only 1/4" long) in the holes of both hinges. Then remove the spring steel retainers above old hinges in the oven frame. These holds hinges in place. Now close the door until hinge stops on pins. Lift up... Read more

The hardest part of this repair was a) realizing that the easiest way to clean the oven door pieces is to remove the whole door and b) figuring out how to put the oven door back on. Doing (b) is infinitely easier if you stick two allen wrenches into the holes in the door hinge, but these holes ONLY appear when the door is fully open. Prop the hinges open BEFORE you remove the door. As many posters online will tell you, it is easy to remove the oven door but hard to put it back on. It... Read more

• Little to no heat when baking

Order a replacement bake element for a 30 years old oven, watched the video on how to replace it, and took about 30 minutes to replace it. It was an easy task. Read more

Called up AppliancePartsPros and ordered the part. My husband took the oven door apart and had it replaced within 15 minutes. Read more