Whirlpool Dishwasher Hose Or Tube

The Manifold is an OEM part for Whirlpool dishwashers. It is located inside the dishwasher and is responsible for delivering water from the inlet valve to key areas during different wash cycles. With drilled port holes machined into durable plastic, the manifold efficiently circulates water where needed.

Causes of a bad manifold can include mineral or sediment build up in the water ports over time, cracking or other physical damage.

Symptoms of a bad Manifold include:

• Water leaks or drips from internal connection points
• Uneven spray patterns from spray arms
• Low or no water pressure during fills
• Incomplete cleaning even on high wash settings

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This replacement Tube-Feed routes fluids inside the appliance to maintain proper operation of the dispense or fill system. It restores correct fluid flow and helps prevent leaks or improper dispensing when the original tube is damaged. What it does:

• Channels fluid between internal components so the unit can fill or dispense as designed
• Helps stop leaks and drips caused by cracked, split, or clogged tubing
• Restores reliable fluid flow when the original tube is kinked, blocked, or degraded
• Reduces symptoms like water pooling, incomplete fills, or dispenser malfunctions

• One Tube-Feed replacement

• Disconnect power and shut off water supply before starting any repair
• Inspect adjoining fittings, clamps, and seals; replace if worn or damaged
• Ensure proper seating and secure clamps to prevent leaks; avoid sharp bends or kinks

This is a drain hose that is used in dishwashers manufactured by Whirlpool. The drain hose helps with the process of keeping dishes clean. When the dishwasher is running, the wastewater is drained via this component. In some cases, the drain hose can become clogged. It also may crack or experience damage. The most common sign that the drain hose is damaged is water that leaks out from under the dishwasher. If there is damage to the drain hose, it will need to be replaced.Before replacing the hose, make sure the dishwasher is unplugged and the water supply is turned off. Disconnect the drain hose from the connection under the sink before removing the bottom access panel on the dishwasher. Remove the brackets attaching the appliance to the counter before disconnecting the drain hose. Install the new hose at the dishwasher and under the sink. Plug in the dishwasher and reconnect water before use.The drain hose is made for use with several dishwashers manufactured by Whirlpool. It is sold as an individual product. This is a genuine OEM replacement part that is directly sourced from the manufacturer.

This flexible drain hose routes wastewater from the appliance to the household drain, restoring proper water removal and helping prevent leaks or overflow. It's a direct replacement hose used where the original drain line is cracked, clogged, or damaged. What it does:

• Carries wastewater away from the appliance to the home's drain or standpipe
• Replaces hoses with cracks, splits, or persistent leaks
• Restores normal draining when kinks or blockages have been cleared
• Secures to the pump or discharge outlet with clamps to prevent leaks

• Disconnect power to the appliance before installing to avoid electrical hazard
• Remove old hose and clamps, inspect outlet and standpipe for obstructions
• Route hose without tight bends or kinks; secure ends with appropriate clamps
• After installation, run a short cycle and check all connections for leaks