Whirlpool Housing Or Cover

This motor cover protects and secures the appliance motor assembly, keeping wiring and components shielded from debris and wear. It restores the motor's protective housing for safer, quieter operation. What it does:

• Shields the motor and wiring from lint, dust, and foreign objects
• Helps maintain proper airflow and component alignment around the motor
• Replaces cracked, broken, or missing housings that leave the motor exposed
• Can reduce rattle or rubbing caused by a damaged motor cover

• Disconnect power to the appliance before beginning any work
• Remove access panels or panels obstructing the motor to reach the mounting location
• Align the cover over the motor and secure with the original fasteners
• Inspect wiring and nearby components while installing; ensure no wires are pinched or contacting moving parts

This blower housing directs dryer airflow from the drum to the exhaust for proper ventilation and consistent drying performance. It replaces a cracked or damaged housing to restore airflow and reduce noise. What it does:

• Channels heated air from the drum to the exhaust vent to maintain drying efficiency
• Helps support the blower wheel and keeps the wheel aligned for smooth operation
• Commonly replaced for reduced airflow, longer dry times, or unusual noise from the rear of the dryer
• Can prevent overheating caused by restricted or leaking airflow

• Disconnect power (and gas supply if applicable) before beginning repair
• Handle edges carefully; wear gloves to avoid cuts and protect the blower wheel
• Reassemble panels and test dryer on a short cycle to confirm airflow and quiet operation

This fan scroll is the blower housing that directs airflow from the blower motor to the appliance's ducts, helping maintain proper circulation. It replaces a damaged or warped housing to restore efficient airflow and reduce noise. What it does:

• Channels air from the blower motor into the appliance air path for cooling or venting.
• Helps maintain consistent temperatures and airflow for proper operation.
• Can reduce vibration or rubbing noises caused by a cracked or deformed housing.
• Supports the blower motor assembly and seals the motor-to-duct interface.

• One fan scroll / blower housing.

• Disconnect power to the appliance before starting any repair.
• Installation may require removal of the blower motor and nearby panels; handle motor and impeller carefully.
• Inspect and reuse or replace any required mounting hardware, gaskets, or seals as needed—only what explicitly ships is included.
• If you hear unusual noises after installation, recheck alignment and clearance between the impeller and the scroll.

This evaporator fan shroud directs airflow from the evaporator fan to the refrigerator's cooling coils, improving cold-air circulation and helping maintain even temperatures in the fresh and freezer compartments. What it does:

• Channels airflow from the evaporator fan to the evaporator coils for efficient heat exchange
• Protects the fan motor and blades from contact with ice and debris
• Helps reduce uneven cooling or warm spots caused by disrupted airflow
• Fits into the evaporator compartment and mates with the fan assembly

• Intended for use in the evaporator compartment;
• Disconnect power to the appliance before accessing internal components to avoid shock or injury
• Handle the shroud gently to avoid damaging tabs or mounting points during removal/installation
• Reassemble panels and test cooling operation after installation

This membrane switch touch pad replaces the worn or unresponsive touch controls on your appliance's control panel to restore normal button responsiveness and user input for oven/range functions. What it does

• Acts as the touch-responsive interface for the appliance control panel.
• Replaces cracked, faded, or unresponsive touch buttons that fail to register commands.
• Helps resolve intermittent or non-working control-pad functions and missed presses.
• Restores tactile/visual button feedback when paired with a functioning display/control board.

• One membrane switch touch pad.

• Disconnect power to the appliance (unplug or switch off circuit breaker) before beginning work.
• Remove control panel trim carefully to access and replace the membrane; avoid bending or creasing the new switch.
• Reconnect ribbon/plug firmly and confirm correct alignment before reassembly.