Dryer Fuse Or Sensor

This thermostat monitors appliance temperature and opens or closes its electrical contacts to regulate heat and protect against overheating. Replacing a failed thermostat restores consistent temperature control and reliable appliance operation. What it does:

• Senses temperature at its mounting location and switches the circuit on/off to regulate heat
• Helps protect the unit by opening the circuit if temperature exceeds its design limit
• A failing thermostat can cause no heat, overheating/shutoffs, or erratic temperature cycling
• Restores correct temperature control when the original thermostat is stuck open/closed or out of tolerance

• 1 thermostat

• Disconnect power; shut off gas supply and allow the appliance to cool completely
• Note wire positions or take a photo; transfer wires one at a time to the new thermostat
• Mount the thermostat flush to the mating surface; reuse proper fasteners for a secure fit
• After installation, monitor initial operation and address airflow/venting or lint buildup that could cause overheating

This thermostat with attached sensing cable detects and regulates appliance temperature to help maintain proper heating cycles and protect against overheating. It replaces a failed temperature control component so your appliance can heat correctly and safely. What it does:

• Senses internal temperature and sends a signal to the control to start or stop heating
• Helps prevent overheating by providing accurate temperature feedback
• Works as the temperature-sensing element used by the appliance control board

• Disconnect power before servicing to avoid electric shock
• Handle the sensing cable and probe gently; do not kink or pinch the capillary/sensor
• Verify proper routing and secure mounting of the sensor per the appliance's service instructions

This safety thermostat detects excessive heat and stops power to the heating system to help prevent overheating and thermal damage. It's a direct-replacement safety cut-out for compatible GE appliances. What it does:

• Opens the circuit when internal temperatures exceed safe limits to shut off the heating element
• Helps prevent overheating, reducing risk of component damage or fire
• Restores normal operation only after cooldown or replacement, depending on design
• Commonly used on ovens, ranges and other heating appliances as a thermal safety device

• One safety thermostat

• Disconnect power to the appliance before servicing to avoid shock or injury
• Note and mark wiring locations or take a photo before removing the old thermostat
• Replace only with the exact part; improper parts may void safety features

This ignition electrode delivers the spark needed to light the burner in compatible gas ovens and ranges, restoring reliable ignition so burners and bake/broil functions light properly. What it does:

• Produces the spark for the gas burner to ignite
• Helps ensure consistent ignition timing and burner starts
• Commonly used when a burner fails to light or ignition is intermittent
• Works with the oven/range ignition system to start bake and broil cycles

• Disconnect power and shut off the gas supply before starting any repair
• Handle the ceramic/insulated tip carefully to avoid cracking or contamination
• Verify correct electrode position and secure mounting for reliable sparking