Estate Washer Parts

Bought a new cord and removed the back of the washer and unclipped the old and clipped in the new. 5 minutes tops. Read more

Door latch was a snap (literally). Package included Instructions and parts for 3 different latch types and an easy identification method for each type. Just identify the correct latch type for your dryer and "Snap" it in to the cutout on the inside of the dryer door . The Door handle requires you unscrew the small sheet metal screws (three on my dryer) on the top edge of the dryer door. This allows you to separate the two dryer door halves (use a small flat blade screw driver to get the two... Read more

Replaced with new retainer clips and new capacitor to fix future problems Read more

• No hot or cold water
• Will not stop filling with water
• Will not fill with water

Ordered this part and just changed it out. Not hard once I figured out how to get in to it. Read more

Im not a repairman, so all my knowledge to fix my washer came from either youtube or online chats. I posted this to help the next dad trying to save a few bucks. Door sensor... Since door sensor worked correctly, verified that by starting washer with door open, and agitate cycle would not start until door was closed. Meaning door sensor worked correctly. Timer... In high spin cycle washer sounded correcltly spinning, but when opening door, drum was was not moving. So timer was triggering... Read more

I diagnosed the problem, identified faulty parts, and replaced those components. Read more

I have a 25 year old Kenmore washer that works well and didn't want to get a new washer as they don't make them like they used to. Upon removing the top cap of the agitator and doing an inspection, the agitator dogs were completely broken into pieces. Due to age we decided to replace the lower and upper agitator along with the agitator auger dogs repair kit. All new parts and works fine. On inspection of old parts, we probably could have gotten away with just a $5 repair for the plastic... Read more

I have a 25 year old Kenmore washer that works well and didn't want to get a new washer as they don't make them like they used to. Upon removing the top cap of the agitator and doing an inspection, the agitator dogs were completely broken into pieces. Due to age we decided to replace the lower and upper agitator along with the agitator auger dogs repair kit. All new parts and works fine. On inspection of old parts, we probably could have gotten away with just a $5 repair for the plastic... Read more

New valve. Read more

Opened lid during cycle and found upper agitator not turning.Removed dust cover seal and saw cam turning but dogs were only engaging once in a while.Although I didn't need to replace the upper agitator I did anyway,along with the agitator cam kit. I watched the quick repair video and repaired the washer myself in less than 30 min. Read more

Bought a new upper agitator/filter housing. Just slide it over the bottom agitator housing and put the cap from the old one on the new one. Takes maybe 3 minutes to do. The screen inside the lower part of the housing/filter holds it snug to the bottom housing and does not fly off during the spin cycle. Works great. Read more

I looked on your site and found troubleshooting diagnostic and then ordered timer. The timer was not hard to remove and install new one. Read more

The problem wasn't a blocked screen. I took apart my washer. Very easy on the Kenmore 600 series. Before I did this, I watched a YouTube video and it was a piece of cake. The whole job took me 35 minutes. Read more

• Will not agitate

Replaced agitator. Read more

Watched the video and completed repair as shown Read more

I had to replace the drive shaft and the lower agitator. The motor coupling was also worn out. The repair was challenging because I had to rebuild the gear box. This step was really messy and I had to wait for the liquid gasket to set prior to completing the repair. Cleaning and prep of all of the parts tripled the repair time. Read more