Frigidaire Dishwasher Dispenser Parts

This cover, volute replaces the outer half of the dryer blower housing to protect the blower assembly and help direct airflow for efficient tumbling. Restores proper airflow path and helps reduce rubbing or contact with the blower wheel. What it does:

• Replaces the dryer blower housing cover that surrounds and shields the blower wheel
• Directs exhaust airflow from the blower to the exhaust duct for correct drying performance
• Helps prevent the blower wheel from rubbing on cabinet parts or allowing foreign objects to reach the blower
• Commonly used when the original cover is cracked, warped, or missing fastener locations

• One cover, volute

• Refer to your model's service manual or diagram for exact placement and screw locations
• Disconnect power and gas before starting any repair to avoid shock or injury
• Handle sharp sheet-metal edges carefully and use appropriate hand tools; reinstall all fasteners securely
• If rust, corrosion, or additional damaged parts are present, inspect the blower wheel and housing for proper fit

This sump housing collects and channels defrost and condensation water to the refrigerator drain system, helping prevent interior pooling and ice buildup. Replaces a cracked or clogged drain housing to restore proper water flow. What it does:

• Guides meltwater from the evaporator area into the drain tube and pan
• Helps prevent water pooling or leaks inside the fresh food or freezer sections
• Reduces ice buildup around the evaporator or under the freezer floor when functioning properly
• Works with the refrigerator's drain tube and pan as part of the defrost drainage path

• One sump housing

• Disconnect power to the appliance before starting work
• Remove food and shelves as needed; allow ice to fully melt before removing the old housing
• Inspect and clean the drain tube and surrounding seals when replacing the housing

This rail end cap is a small trim piece that covers and protects the exposed end of a drawer or door rail, restoring a finished appearance and preventing snags. Easy-to-replace part for worn, cracked, or missing rail ends. What it does:

• Covers the open end of a metal or plastic rail to prevent clothing or towels from catching
• Restores the original finished look to a drawer or door rail
• Helps keep dirt and debris out of the rail opening
• Prevents sharp or rough rail edges from causing wear or injury

• One rail end cap

• Typically installs by pressing onto the rail end until fully seated; may require light prying of the old cap
• Use a plastic trim tool or flat screwdriver with care to avoid scratching surrounding surfaces
• No advanced tools required; disconnect power only if working near energized controls
• If cap is brittle or breaks during removal, replace any retained clips or fasteners as needed

This replacement cover restores the appliance's exterior finish and protects internal components from dust and debris. It gives a clean look while shielding controls and wiring from accidental contact. What it does:

• Protects internal components, wiring and control modules from dust, spills and damage
• Helps prevent accidental contact with electrical parts for safer operation
• Restores a cracked, broken or missing trim piece to improve appliance appearance
• Keeps vents and openings properly covered to maintain intended airflow paths

• Disconnect power to the appliance before beginning any repair
• Remove any trim or fasteners that secure the old cover; some screws or clips may be used
• Handle edges carefully—use gloves if needed to avoid cuts
• Follow model-specific instructions for exact removal and reassembly steps