Frigidaire Dishwasher Parts

Red

Seals the turbidity sensor assembly to maintain watertight connection and accurate water clarity readings. Replace if leaking or sensor malfunctions.

Secures dishwasher hoses to prevent leaks and water damage. Replace if loose, cracked, or leaking. Verify fit with your model number before ordering.

This replacement insert restores the finished trim and proper fit where the original trim or panel insert is cracked, missing, or worn. It helps return a clean, secure appearance and supports adjacent panels. What it does:

• Replaces a damaged or missing trim/insert piece to restore appearance and fit
• Helps eliminate visible gaps and prevents adjacent panels from shifting
• Reduces rattling from loose trim pieces during operation
• Preserves the original mounting alignment for nearby components

• Disconnect power to the appliance before starting any work
• Remove any surrounding trim or panels carefully to access the insert; keep fasteners for reuse
• Install by aligning with existing mounting tabs/slots and secure with original hardware; do not force into place

Replace the control panel touch pad on your dishwasher. Mounts on the door to house buttons and display. Order a new touch pad if yours is cracked or worn.

Replacement dishwasher door hinge pin that connects the door to the frame. Needed when the original pin is worn, bent, or broken causing door alignment issues.

Fix a dishwasher that won't start cycles, shuts down mid-cycle, or shows error codes. This control board manages all functions and cycle timing.

A replacement bearing that supports the dryer drum and restores smoother, quieter rotation. Replaces a worn or damaged bearing to help reduce noise and prevent excess drum play. What it does

• Provides a low-friction mounting point for the drum shaft to rotate smoothly
• Keeps the drum aligned and reduces wobble during operation
• Helps prevent metal-on-metal contact that causes grinding or rumbling noises
• Can reduce strain on the motor and belt by restoring proper drum support

• Disconnect power before beginning any disassembly
• Replacement typically requires removing panels and the drum;
• Inspect surrounding seals, shafts, and mounting hardware and replace if worn

Mounting bracket for dishwashers. Secures components inside the cabinet. Order a replacement if your bracket is bent, cracked, or missing.

Replacement mounting screw for dishwasher panels and components. Secures loose panels, brackets, and trim. Needed when original fasteners are missing, stripped, or worn.

Touch pad control panel for dishwasher. Replaces worn, cracked, or unresponsive touch control interface. Installs on front console assembly.

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.

Small plastic end caps that prevent the dish rack from sliding too far in either direction within the dishwasher tub. Located at the ends of the upper or lower dish rack rails. Replace if the rack slides out too far, falls off the rails, or doesn't stay properly positioned during operation.

Fix detergent not dispensing or dispenser door not opening with this dishwasher dispenser shaft kit. Repairs broken or worn dispenser mechanisms.

Right side door hinge for dishwashers. Replaces cracked, broken, or worn hinges that prevent the door from opening and closing smoothly or securely.

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.