Frigidaire Dishwasher Parts

Replacement mounting screw for dishwasher panels and components. Secures loose panels, brackets, and trim. Needed when original fasteners are missing, stripped, or worn.

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.

Replacement door spring for dishwashers. Installs inside the door hinge to provide tension and smooth operation. Replace if broken, stretched, or missing.

Small plastic end caps that prevent the dish rack from sliding too far in either direction within the dishwasher tub. Located at the ends of the upper or lower dish rack rails. Replace if the rack slides out too far, falls off the rails, or doesn't stay properly positioned during operation.

Fix detergent not dispensing or dispenser door not opening with this dishwasher dispenser shaft kit. Repairs broken or worn dispenser mechanisms.

Right side door hinge for dishwashers. Replaces cracked, broken, or worn hinges that prevent the door from opening and closing smoothly or securely.

Replacement dishwasher filter chopper blade that grinds food particles in the sump assembly. Replace if dishes aren't cleaning well or you hear grinding noise. Verify fit by model number.

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Support assembly panel for dishwashers. Secures internal components and maintains structural integrity. Replace if cracked, broken, or missing.

Secures hoses on water and drain connections to prevent leaks. Replace when clamps corrode or lose tension. Verify fit with your model number.

NOTE:  Wheels are no longer included with this part.

Replaces a rusty, cracked, or damaged dishwasher upper rack. Restores smooth gliding and secure loading for cups and bowls on the top level.

This bezel is a trim piece for Frigidaire dishwashers that finishes and protects an opening on the door/control panel, helping the mating component sit properly while restoring a clean, factory look.

• Frames and protects the panel opening for a control or latch component
• Helps keep the mating part aligned and seated correctly
• Covers raw edges and gaps to reduce wear and debris buildup
• Common symptoms: broken or missing trim, loose/wobbly bezel, cracked retaining tabs, cosmetic damage

• Disconnect power to the dishwasher before servicing
• Remove the control knob or latch handle to access the bezel
• Release the bezel's retaining tabs/clips and lift it out from the panel
• Align the new bezel and snap/secure it into place; reinstall any removed parts and test operation

Replace your worn, bent, or damaged dishwasher lower rack. Restores secure support for plates, bowls, and cookware. Durable grey finish protects dishes.