Frigidaire Dishwasher Parts

Easy job, I screwed the parts to the dishwasher Read more

Replaced it. Read more

The key was that information section that shows what model of dishwasher is compatible it was the only site I could find Read more

The fix took 30 seconds. The key to success was your video that explained how reinstalled parts "lock in". Read more

Replaced on of the arms with the proper adjustment Read more

Took cover completely off and tried putting back, could not match up left screw with available screw hole. Tried many different configurations and sequences to make this happen. watched a video on changing the front panel, the door in it had four screws, mine 2, no help there. Searched on the hyperextending issue, found an article about dogs and kids [had both here] climbing on the door and to check the springs and linkages. Linkages intact both sides, R [opposite] side spring very stretched.... Read more

Replaced racks, Read more

Replaced four rollers & slide. Read more

Removed broken arm and snaped new one in place. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

• Door latch failure
• Door won't close

Replaced the door strike Read more

This was a pretty easy fix. Removed the screws around the perimeter of the inside cover of the door and pressed the outer door cover upward to release it from slots retaining it. There are four wires to remove (2 for the detergent door release and 2 for the rinse agent release). Removed the 6 screws retaining the dispenser assembly and inserted the new one. Reassembly is simply in reverse order. Problem solved for less than the cost of a service technician's call! Read more

Easy job, I screwed the parts to the dishwasher Read more

I started looking at new dishwashers and was quickly disheartened with the cost of these simple machines. There's really not much to them and yet they're so much money for what they do. I popped off the pump and took a look at it and cleared some "gunk" and hair out but it didn't fix the issue. Jumped on AppliandPartsPros.com and ordered the pump on a Friday night and had the part in hand Tuesday night after work. Took about 10 minutes total (dishwasher out and back installed, literally in... Read more

So I replaced the hi-temp thermostat and the problem is fixed. Read more