Frigidaire Range Parts

Oven not heating or baking unevenly? This bake heating element restores consistent temperatures. Common DIY fix for most home cooks in under an hour.

This control-panel switch restores reliable on/off control of a selected function on your range or wall oven. Replacing a worn or intermittent switch helps ensure the appliance responds consistently when you toggle that function.

• Directs power to the associated circuit when switched on or off
• Common symptoms: function won't turn on/off, intermittent operation, or the switch feels loose/sticks
• Helps restore positive, consistent control from the backguard/control panel

• Disconnect power at the breaker before servicing
• Access the switch from the control panel/backguard; retain screws/clips
• Label/photograph wire positions and transfer leads one at a time to the new switch
• Ensure firm terminal connections, reassemble, restore power, and test operation

Oven won't heat or takes too long to preheat? A failed bake element is the likely cause. This bottom heating element is a straightforward 15-minute DIY fix.

Cosmetic overlay that covers and protects your range's control panel surface. Replace if scratched, cracked, peeling, or worn from kitchen use and spills.

Fix oven that won't heat, inaccurate temperatures, or unresponsive display with this electronic control board. Restores bake/broil functions. 15-minute DIY.

Replacement spring for microwave door latch mechanism. Restores return tension so the latch engages and releases correctly. Needed when spring is broken or worn.

This is the main water supply tube assembly that routes wash water from the pump to the spray system. A damaged or leaking tube can reduce spray pressure and cleaning performance or allow water to escape during a cycle.

• Directs pressurized water from the sump/pump to the spray arm/manifold
• Helps maintain proper wash pressure and coverage
• Common failure signs: weak or no spray, poor cleaning, leaks from the back/under door area, or visible cracks in the tube
• Restores correct water flow path for consistent wash results

• Unplug power and turn off water to the appliance before service
• Remove lower rack and spray arm/manifold as needed to access the tube
• Inspect and transfer any reusable clips or seals if not integral to the assembly
• Ensure all connections seat fully and test for leaks after reassembly

Replacement surface burner for gas range cooktops. Installs directly onto the burner base. Order when your existing burner is cracked, clogged, or missing.

Supports and guides your range oven door for smooth opening and closing. Replace if hinge is broken, collapsed, or causing door misalignment issues.

This factory wire harness routes electrical power and signals between the controls and internal components of your cooking appliance. Replacing a burned or brittle harness restores safe, reliable connections and helps prevent shorts or intermittent operation.

• Distributes power and control signals between the user interface/control system and internal components
• Replaces damaged wires or connectors that can cause no operation or intermittent function
• Helps address short-to-ground conditions that trip a household breaker
• Restores proper routing to reduce wire chafing and heat exposure

• Disconnect power at the breaker or unplug the appliance before servicing
• Photograph/label connections and transfer one connector at a time to match original locations
• Route along factory paths and secure with existing clips/ties; keep clear of sharp edges and hot surfaces
• Inspect mating terminals for heat damage and repair/replace affected parts before reassembly

Replacement control knob for your range. Restores smooth dial operation when original knob is cracked, broken, peeling, or worn. Sold individually.

Igniter and orifice assembly includes igniter, orifice, and gas tube. Replace if cracked, corroded, or broken. Installs under range top at burner base.

Replace a cracked, chipped, or missing burner cap on your gas range or cooktop. Restores a clean look and protects the burner assembly underneath.

Seals your oven door to retain heat and maintain consistent cooking temperatures. Replace when worn, cracked, or after self-clean cycles. Verify fit.

Fixes dual burner when inner ring stops heating or entire element fails. Common cooktop repair—disconnect power, lift top, replace element. Takes 30-60 minutes.

Oven won't heat, slow to reach temperature, or glows dull orange? This igniter fixes weak ignition. Moderate DIY repair with basic hand tools.