Frigidaire Refrigerator Touch Pad

I replaced the part by popping off the plastic frame and removing several easily-accessable screws. Three small electrical plugs had to be popped off too. It was a very simple repair. The Sears guy wanted $395 total for the repair, and I did it myself for the price of the part on this site (around $90). Very pleased! Read more

Replaced solonoid. Video was very helpful. Parts came in the time frame given when I ordered the part. (1.7 days). Without the video I would have called a repairman. Thanks . Read more

So I ordered the face plate and other parts that went with it and fixed it myself. The repair man wanted around $600 to do it. I believe kt cost around $160 to fix it myself. Read more

Replace dispenser micro switch. Also replaced broken faceplate and rusty screws. Appliance parts Pro YouTube video was helpful in diagnosis and disassembly. Parts arrived quickly. Read more

So I ordered the face plate and other parts that went with it and fixed it myself. The repair man wanted around $600 to do it. I believe kt cost around $160 to fix it myself. Read more

Replaced with ordered cover and new screws. Cover was a perfect replacement for original. Replacement took less than 15 minutes to complete. Read more

Removed old label, took the glue residue off, wiped it down with rubbing alcohol then attached the new label on to the fridge. Read more

I googled my refrigerator model number and the problem. It brought me to a message board with a thread about my exact problem. A seasoned tech answered the persons question about their ice not dispensing by stating they needed to replace the module-dispenser because of a faulty switch. He also stated he didn't think the switch was a part that could be ordered. He suggested I order from you and stated if it did not fix the problem, I could easily return it for a full refund but I would have to... Read more

Ordered replacement part and changed it out myself. Was pretty simple except for the fact that I could not get the trim ring around the dispenser unit entirely off the door. I was able to start at the top and pull it out enough to change part, but was afraid to pull too hard on it for full removal thinking it could break. Unscrew part from door, disconnect wire harness to part, remove, re-connect new part and re-install. Read more

Took off the old one and put the new one on. Just snapped it into place. Read more

Replace the control. Order part from appliancepartspros. All is working. Thank You. Read more

Painted change water dispenser control panel to match oem. Read more