Frigidaire Refrigerator Wire, Harness, Power Cord

This wiring harness routes power and signals between the appliance control and components while protecting solenoid valves with integrated diodes. It restores reliable electrical connections so controls and valves can operate correctly. What it does:

• Provides the factory wiring path between control board, valves and related components
• Integrated valve diodes suppress back-EMF from solenoid coils to protect electronics
• Restores lost or intermittent power to valves and sensors caused by damaged wiring
• Helps stop symptoms like valves not actuating, intermittent ice/water operation, or control errors tied to wiring faults

• Disconnect power before beginning work to avoid shock or component damage
• Carefully document or photograph original wire routing and connector locations for correct reassembly
• Plug connectors fully; secure harness with existing clips or ties to prevent chafing
• If terminals are corroded or connectors damaged, replace connectors rather than splicing for a reliable repair

This wiring harness routes power and signals between the appliance control and its components, restoring reliable electrical connections for proper operation. Use this direct-fit replacement when the original harness is damaged or intermittent. What it does

• Provides dedicated wiring between the main control and motors, valves, switches or sensors
• Replaces brittle, frayed or burned wires that can cause intermittent operation or failed components
• Restores missing circuits that prevent the appliance from starting or running specific functions
• Helps stop electrical arcing and loss of connectivity when the original harness insulation is compromised

• One wiring harness

• Disconnect power (unplug or switch off breaker) before beginning any repair
• Compare new harness to the old unit to verify routing and connector fit before installation
• Route and secure the harness away from moving parts and heat sources; use existing clips and ties
• If connectors are corroded or pins are damaged, replace connectors

This wiring harness is the appliance's pre-wired connector assembly that routes power and signals between the control and components, restoring proper electrical connections for reliable operation. What it does

• Connects control board, motors, sensors and switches so components receive power and communicate.
• Replaces damaged or frayed wiring that can cause intermittent operation or component failure.
• Stops symptoms like no power to a component, intermittent cycles, blown fuses or visible arcing at connectors.
• Ensures secure plug-to-plug connections and correct wire routing when installed correctly.

• Disconnect power to the appliance before attempting any repair to avoid shock.
• Compare the harness and connector shapes to the original before installing; route wires away from heat and moving parts.
• Secure connectors fully until they click; do not force mismatched plugs.
• If terminals are corroded or connectors are damaged at either end, replace harness or repair terminals per OEM instructions.