General Electric Dryer Parts

Seals and cushions the dryer drum edge to prevent fabric catching, reduce noise, and direct airflow. Replace when worn or torn. Verify fit with model number.

Complete dryer door assembly replaces damaged, cracked, or broken doors. Includes frame, glass, and mounting hardware for full door replacement.

This inner door sub-assembly is the factory replacement inner panel for the appliance door. It restores the door's inner structure and supports the inner glass and trim for safe, stable operation. What it does

• Replaces a damaged or warped inner door panel that can allow heat/steam to collect between door layers
• Secures and supports inner glass and related trim for proper door alignment
• Reduces rattling or vibration caused by a loose or broken inner door component
• Helps restore a proper seal and consistent cooking/heating performance when the inner panel is compromised

• One inner door sub-assembly

• Disconnect power (and gas, if applicable) before beginning any repair; ensure appliance is cool
• Handle glass and sharp edges carefully; wear gloves and eye protection
• Follow the OEM service manual for disassembly/reassembly steps and recommended fasteners

Dryer not heating or taking too long to dry clothes? This heating element heats air as it passes through the blower. Moderately difficult repair.

Dryer not heating or taking too long to dry? This heating element generates the heat needed to dry clothes efficiently. Moderate DIY repair.

This part is a genuine OEM condenser assembly made for use with dryers. The condenser moves hot air to the condensing chamber to condense it into water, which is then collected underneath the appliance. Over time, the condenser may become faulty, which will prevent it from working properly. The user may start to notice clothes are still damp, even after a full cycle. In this case, the condenser should be immediately replaced. Make sure to unplug the dryer from the outlet to prevent serious injuries when undergoing the replacement process.This part is manufactured by General Electric and has been sourced directly from the manufacturer. It is sold individually. It is an authentic replacement part and thus is compatible with dryers manufactured by General Electric, Hotpoint, and RCA.

Dryer not heating or taking too long to dry? This heating element generates the heat needed to dry clothes. Moderate difficulty repair, typically 30-45 minutes.

Structural bracket that supports and secures the dryer motor in place. Replace if cracked, bent, or broken to properly mount the motor assembly.

Felt cushioning strip that mounts to dryer bracket or cabinet to reduce metal contact and quiet vibration. Replace if worn, compressed, or missing.

Secures the terminal block to your dryer's electrical assembly. Replace if cracked, broken, or missing to properly mount the terminal connection block.

Secures the dryer motor in place within the cabinet. Replace if strap is cracked, broken, or missing to properly mount and stabilize the motor assembly.

Channels hot air from your dryer to the exterior vent system. Replace if cracked, torn, disconnected, or showing heat damage for proper airflow.

Replace a cracked or broken dryer blower housing. This cover protects the blower wheel assembly and mounts inside the dryer cabinet near the drum.

Drum heat deflector directs hot air evenly inside your dryer. Replace if cracked, warped, or missing to restore proper airflow and protect drum.

Replace your dryer's exhaust duct hose if cracked, torn, or disconnected. This vent hose directs hot air from the dryer drum to the outside vent opening.

Replace your dryer's broken or cracked drum baffle to restore proper tumbling action. This internal component lifts and tumbles clothes during cycles.