General Electric Refrigerator Support Parts

A stamped mounting plate that secures the compressor to the refrigerator cabinet, helping keep the compressor stable and reducing vibration during operation. Fits original-equipment compressor assemblies. What it does:

• Provides a secure mounting surface to fasten the compressor to the cabinet frame
• Dampens and reduces compressor vibration that can cause noise or movement
• Keeps the compressor properly aligned for reliable refrigerant line routing
• Helps prevent stress on compressor mounts and surrounding components

• One compressor mounting plate

• Disconnect power to the appliance before starting any repair
• Support the compressor while removing and installing the plate to avoid strain on refrigerant lines
• Use the original mounting hardware when possible; replacement fasteners if needed

This holder element assembly secures the appliance's heating element in the correct position so the element stays stable for consistent operation and safe performance. It's a direct-fit replacement for worn or damaged holders. What it does:

• Secures and supports the heating element inside the appliance to maintain proper alignment
• Prevents element sagging or contact with other components that can cause noise or arcing
• Helps reduce vibration and movement that can lead to intermittent heating
• Common symptom: visible holder damage, loose or shifted element, unusual noise during operation

• Disconnect power (unplug or switch off breaker) before starting any repair
• Allow appliance and element to fully cool before handling
• Handle the element and holder carefully to avoid bending or damaging the element

This support rail VP cover replaces a worn or damaged trim piece on the refrigerator support rail, restoring a finished look and helping keep items properly seated. Fits where the support rail meets the cabinet trim. What it does

• Covers and protects the end of the support rail trim from chips and wear
• Helps keep shelves or bins aligned and from sliding past the rail
• Restores the original finished appearance of the rail area
• Commonly replaced when cracked, broken, or missing after impact

• One support rail VP cover

• Basic snap-on or screw-in installation; match orientation before securing
• Turn off and empty the affected shelf/bin area for safer access
• Inspect mating rail and fasteners for damage; replace any broken clips

Color: White

This evaporator trough catch secures the defrost/drip trough under the evaporator to guide melting water into the refrigerator drain, helping prevent water from pooling inside the freezer or cabinet. Fits as a direct replacement for the original part. What it does

• Holds the evaporator/drip trough in the correct position so defrost water flows to the drain.
• Helps prevent water from leaking or pooling inside the freezer compartment.
• Supports proper defrost drainage to reduce the chance of ice buildup around the evaporator area.
• Works with existing trough and drain components to restore normal water flow.

• 1 evaporator trough catch

• Disconnect power to the appliance before starting any work to avoid electrical shock.
• Access usually requires removing the evaporator cover or rear freezer liner; keep parts and fasteners organized.
• Handle evaporator and surrounding components carefully to avoid damage to fins, tubing, or gaskets.
• Replace any additional damaged or corroded parts found while servicing for reliable operation.