Gibson Parts

• Leaking

Changed the Frigidaire Icemaker Fill Tube Part # 241796405 (AP5671747) about a week ago and so far the Frigidaire Refrigerator seems to work fine. Did not use other ordered parts. Recently ice formed around internal evaporator fan and it started making loud noise when then fan and compressor, etc were running. A long winded history noted below if interested: I have been fighting with this Frigidaire Refrigerator for about 3 to 4 years, started out with the evaporator fan making noise when ice... Read more

Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension. Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end... Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

• Door latch failure
• Door won't close

Replaced the door strike Read more

I watched the helpful diy video. It gave me what the problem was and the confidence to do it. Took my dryer apart with the helpful hints in the video repair went smooth. Works like a dream and I saved money. Thank you appliance parts pros. Read more

I had purchased a model refrigerator that did not come with the deli/meat pan, and I was told by the manufacturer's customer service department that my purchased model was not designed with the item. I made comparisons with other models that had the deli/meat pan and found that the shelving alignments were the same so I decided to improvise and install the deli/meat pan. The manufacturer's customer service department did assist me with obtaining the appropriate part numbers and I placed the... Read more

• Leaking
• Not dispensing water

Turned off water behind the fridge. Unscrewed housing that covered water lines behind the filter base with a 1/4" socket. Pulled out the water hoses by pulling forward on the blue ring holding the hose while pulling the hose backward. Unscrewed the two screws below the filter base. Used the 1/4" socket to remove four additional 1/4" nuts holding the front housing until it partially dropped. I kept the housing propped on a jar. Unscrewed two additional screws holding the filter release rod in... Read more

I went online, ordered the part and installed it,,, took 15 minutes to install,,,saved huge $$$ easy peasy!! :-) Read more

Ordered on Wed, received on Fri. Took less than 5 minutes to replace all 4. No tools needed. Read more

Ordered the part, received it in a couple of days and whammo, everything is fine. So easy. Read more

Had to pull double oven and range top out from wall which involved removing the upper kitchen cabinet. Took the sheet metal off the back and had the socket swapped out in a couple of minutes. My old oven works like a charm! Read more

I manually rotated the drum and could hear a noise in the lower right hand corner of the dryer. I turned off the breaker, removed the front covers to expose the blower fan. Blower fan was no longer attached to shaft and hitting the housing. Ordered a new blower assembly, rear bearing kit and lint filter on Friday at 09:00 AM and they arrived the next day at 13:00 (with standard shipping !!). 15 mins to troubleshoot. 30 minutes to replace parts and re-assemble. Running like new again !! ... Read more

I wasn't sure if it was the door being warped, the spring return being worn, or the rotary damper failing, so I ordered all to update the door mechanism. I also ordered a new micro switch since one of the switches had started to require more and more pressure to actuate. Figured I'd fix it at the same time. Repair was very straightforward and the videos available on this and other repair sites were very helpful. I found a video that showed replacing the door mechanism on a nearly identical... Read more

• Light not working

Ordered switch....turned out it was the socket that was bad...ordered socket.....quick install....light works Read more

• Won't start

This is a Montgomery Ward gas range made by Tappan. Parts are no longer offered for this appliance. So, I had to eyeball various ignitors to determine which one would work. I settled on the least expensive one and ordered two (Just in case there were "issues"). The parts arrived quickly but were not a simple drop-in replacement. The new ones were longer and smaller in diameter. I had to use the original bracket because it provided the electrical ground for the spark. I used a spring to... Read more