Gibson Parts

Needed to replace burner box panel (pan under electric coil burners) and replace stove top (black panel that surrounds the burners). BB was corroded, had a couple big holes from liquid boil-overs (salted water) from the last 10 years. The stove top looked nasty. It was chipped & scratched badly. Removed electric coil burners and drip pans from stove top. Removed 1 small Phillips screw in each burner opening to detach electrical burner sockets from stove top. Lift stove top and support on prop... Read more

Put in missing o-ring Read more

I had a friend and a repair guy tell me it was the start relay that needed to be replaced, which was an easy fix. My friend said just to unplug the start relay, replace it with the new one, and it should be good. I've never tried to repair a fridge, and that was the easiest repair ever. Saved us hundreds of dollars! Read more

We took the old ones off and put the new ones on..it was easy to do ..I want to say that the girl (I think her name was Heidi) she was a big help ,she made sure that I had the right parts,I ask her to show me the picture to make sure that they look like the part ..She was a really big help. I did a survey when I ordered the parts to..Thank you for your help and the parts Anna P Read more

I purchased 2 new light rocker switches, Because the heating element rocker switch was unavailable. First I removed the power source for safety. Then I simply pulled each switch out individually with a flathead screwdriver for leverage. I simply unplugged the wires from the old rocker switch, discarded the old rocker, plugged the wires into the new rocker switch, and pushed the new switch appropriately back into the control panel. I used the same steps for both rocker switches. Once... Read more

Replaced the damper control after looking at the exploded drawings privided by this website and determing that the bad part was the damper control. I have never done a repair on an appliance before but this website made it seem doable. Read more

Walk into the kitchen on 21 Sep. Eight year old Frigidaire refrigerator appears to be short cycling, controls are nonfunctional. Unplug it for a few minutes, plug it back in, appears to return to normal function. Return to kitchen half hour 45 minutes later it's short cycling again. Panel has codes on it (S or 5 E CE, later that changes to S or 5 Y CE). Research of codes says replace main board and control board. Not sure where this main board is. 22 Sep call appliance repair. "Soonest... Read more

We ordered the appropriate parts and reassembled the shelf, replacing damaged parts. Read more

Ordered new one Read more

This was a 2000 model so rather than just replace the defrost timer which was visibly burnt on the terminals, we just did everything. The cold control, defrost timer, thermostat, defrost heater and the compressor capacitor were all replaced. I had the same issue on my older unit and tore it apart replacing one item at a time over a three month period so on an older one i suggest do it all while it is apart. Read more

I ordered new racks online while talking to a rep from Appliance Parts Pros.com. She told me about flat shipping rate of $6.95 and to expect 5-7 days. The racks arrived the following day!!!! Read more

It was easy to find the part on appliance parts pros. Once I found it I studied the diagram and determined that there were 3 screws in the drum that needed to be removed. I disconnected power and then removed 3 interior screws. Once I did that I removed the back cover and removed the single screw on the bottom side of the air duct that held it in place connected to the heat tube. I then reversed disassembly. I want to tell you this is a 2 person job. In order to assemble it you need to... Read more

I encountered a high pitched squeal and loud rumbling. I figured the sounds were likely the rollers despite not matching other sounds on the repair videos for other dryers. The repair video for dryer rollers on AppliancePartsPros.com is of little use until Minute 2:56 because this Electrolux 517 model uses mostly Phillips head screw to fasten the front and top panels in place. You may find one latch at the top front center that holds the top and front panels in place. After unplugging the... Read more

I replaced the door boot with a new one from AppliancePartsPros.com. The most difficult part was starting at the back end of the new boot onto the stationary rim, just in front of the tub. And then anchoring it in place with the existing spring from the previous boot. To start the boot I had to hook the top edge of the boot, where the arrow tab is, onto the rectangular projection on the tub rim and then roll the rubber boot edge down around the tub rim and hope the rim was going into the... Read more

I took and ohm meter to the heating element and figured out that was ok. Went to the thermostat and it was toast. Easy fix. Read more

Changed element Read more