Ikea Parts

Replaced the dual water intake valve Read more

I unplugged the stove ,cut the 50 amp cord off from the terminal block as it was burned took out the terminal block as it to was all melted .installed the new terminal block with a new stove cord back in business Read more

Replaced switch pad Read more

After inspecting screen and drain hose with no obvious cause, replaced drain pump. Removal of the pump was very straight forward. 3 screws, 2 electric connections, and 1 hose clamp was all that was needed. Read more

Purchased door springs from Appliance Parts pros.com, installed them and door on our Dishwasher was back to normal, Had to pull out dishwasher from under cupboard to get to springs, as they were on the sides of the dishwasher. Read more

First tried replacing the seal around the door as that was the simple and most logical fix. Still leaked. Removed the front and upper panel to inspect. Found calcium deposit running down from under the Air Vent Assembly and wet behind the black stick-on insulation. Easy to trace the leak to the bottom of the door. => Ordered new Air Vent Assembly, gasket and Vent Deflector. Parts arrived. Took 5 minutes to remove upper panel. Removed the two wires from the Air Vent Assembly. Inserted a... Read more

• Will not fill with water

Replacing the inlet valve solved the problem. The old valve was somehow clogged with white sediment. I probably could have taken it off and cleaned it out if I'd known, but replacing the valve was much easier. Took about half an hour to repair. Video walk through was extremely helpful. Great to have a working dishwasher again! Read more

Great, I had my two new hinge door's put on in about 10-15 minutes Read more

Ordered replacement parts Read more

The repair was a success. The switch and came looked different from the original. I called Appliance Parts Pro, they lady on the phone said that Frigidaire changed the switch and how to wire it up correctly. Problem solved. It all works as it should. Read more

Ordered new wheel assembly, which came in about a day and a half. The broken assembly was on the left front so I only had to slide the dishwasher out just enough to expose the two mounting screws on the outside of machine.When you remove the old assm there are two rubber washers on the back side. If you didn't order new ones,remember to remove them from broken assembly and install them onto the new piece.Overall this is an easy fix and took about ten minutes including pulling the machine away... Read more

Bought a replacement gasket. Read more

I replaced the Inlet Valve. The part arrived ahead of schedule and was approximately $10 cheaper from AppliancePartsPros.com. This is the second time that I ordered parts from this company and have had great success with each one. Thanks Larry Read more

Replaced the regulator with part #AP5802175. Watched the video when purchasing, and it was spot on. Would have taken me about 15-20 minutes if I had access to a vise, to remove one of the fittings. Was able to get it out using two wrenches, but it was not without a bit of elbow grease. The new part went in easily. Turned on valve on regulator, plugged in the power, turned on the gas valve, done. Everything worked fine. Easy job for anyone with just a few tools. Read more

Replaced the auger motor. Read more

Replaced the oven heating element Read more