Ikea Parts

Replaced the element. 1st- Turn off the power to the appliance. The cook top is held on with two screws - access the screws by opening the oven door. Cooktop is hinged, so just pull up near oven door and hold in place with, say, a three foot long stick. The elements are held in place by bracket attached to the cooktop. Remove the bracket by removing the two socket screws. The element is aligned to the bracket with three locking tabs. Remove the tabs with pliers. I broke off one the... Read more

Replaced spray arms and tube. Found all had debris in them and prohibited water pressure from reaching items. After replacement everything comes out sparkling. Don't understand how the spray arms getting plugged. Almost like waste water is recycled. Turns out to be a very easy project and if needed AppliancePartsPro has information and directions available at your finger tips.! Read more

Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension. Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end... Read more

Replaced with new kickplate panel. Didn't exactly match our unit but was the right length & lined up correctly enough to allow me to zip tie it to the frame properly. Read more

Replaced the motor and fan blades exelente fitting work great Read more

Removed the plastic shield, then unscrewed old bulb. Screwed in new bulb. New bulb has a slightly different screw base. Looked in several stores that carry appliance bulbs and could not find any bulbs that matched the unusual screw base. Replacing the snap-in plastic shield was difficult. It might have been easier if I had taken the freezer drawer out. Read more

Located appropriately sized door gaskets. Read more

I got on appliance parts pros website, looked up my model number. Using their diagrams I found my part. Ordered it and replaced it, just like the new one. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

Replaced Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

Replaced it completely in less than an hour. Part was exact OEM replacement and worked perfectly. Read more

Replaced the thermst-fix and the thermal fuse oven now works great Read more

I started looking at new dishwashers and was quickly disheartened with the cost of these simple machines. There's really not much to them and yet they're so much money for what they do. I popped off the pump and took a look at it and cleared some "gunk" and hair out but it didn't fix the issue. Jumped on AppliandPartsPros.com and ordered the pump on a Friday night and had the part in hand Tuesday night after work. Took about 10 minutes total (dishwasher out and back installed, literally in... Read more