Ikea Refrigerator Motor

Top mounted freezer with bottom refrigerator. Kenmore Elite Shut off the power Remove all food stuff from freezer (placed in ice chest) then shelves. Removed the ice maker, (easy!) 3 screws and unplugged wires. 2 screws in the back panel. Pulled top forward - downward Unplugged wiring harness from back wall of freezer, removed ground wire from panel Pulled fan blade off. (Fan was attached to back wall, not removable back panel) Removed 2 screws to get to fan motor. 'Unsnapped ' motor... Read more

Remove the ice bucket remove screws from one side of shaft remove screws from other end of shaft replace moter easy fix Read more

It was a pretty easy fix not as easy as the 1 nut models they show on YouTube it had 3 tiny ones that my big hands had a bit of trouble with. It said 15 minutes it took me about a half an hour. I called a service company just to see what they would charge. $90.00 to say hello 1 hour minimal labor $110.00 and $120.00 for the part. It cost me $90.00 and 30 minutes of my time. Thank you appliance pro. Read more

Used U-Tube diagnostic clips to diagnose that most likely problem was a worn Evaporator Fan Motor which is located in the freezer back wall, located in the top third of the unit. I removed 6 hex head screws from the freezer's interior back panel that covers the evaporator coils. The cover is located in the lower 2/3s of the back wall. Removed all shelving. Also removed screws that held in shelf supports on one side of the freezer wall. I then removed the back panel. You may need to... Read more

Removed the back cover to access the fan area. Clean the area with brush and vac first. Unplugged the Refrigerator. Used a socket set with 1/4" socket. Had an extended and a standard socket. Removed the condensate plastic drain from the bottom of the refrigerator to have more access to the fan. Unplugged the fan motor. Removed the two screws holding the fan in place. Removed the fan unit from the condenser side of the bracket. Place new fan on the fan and installed exactly the way I removed the... Read more

I bought the listed condenser fan motor for my Maytag refrigerator. Access to the condenser fan is by removing sheet metal screws of bottom panel with 1/4 in. nut driver. Condenser fan is on left side of rear access area. Remove electrical connector by pressing-in connector release tab with thumb fingernail and pulling on connector. Remove three mounting screws with 5/16 nut driver. Work fan out to the right past the compressor. I used a pair of pliers, as a lever, behind the plastic fan blades... Read more

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

My KitchenAid refrigerator was not cooling, but the freezer was working perfectly. The help section here listed three parts that could be defective–defrost thermostat, evaporator fan motor and blade, and air diffuser/damper control–so I replaced them all. The videos were EXCELLENT, and despite the difficulty I had squeezing my shoulders into the small freezer compartment, I installed the parts and my refrigerator is cooling perfectly! THANK YOU FOR THE EXCELLENT REPAIR VIDEOS! I am so happy... Read more

Removed the rear cover from inside the freezer section, found the evap fan not working. Ordered replacement motor, easy change. Read more

The tech was very helpful. We needed a new motor. Read more

Replaced the fan Read more

I removed the fresh food ice maker found the drain tube for ice maker frozen. This was causing the back of the unit to rust out. This also caused the water to run down the back of the unit the into the duct work and into the freezer causing ice buildup. I then defrosted the freezer removed the rear duct work and the freezer drain pan cover. I found the freezer drain was not draining. I removed the exterior rear cardboard cover and located the freezer drain tube removed it and found that it was... Read more

Originally thought it was the evap fan motor, possibly the control board. Turns out it was the latter but only way to know for sure was to replace fan first. Shipping was fast and the parts were good. Read more

Replaced fan motor Read more