Ikea Refrigerator Parts

It was a 5 second job! The part clicked into place so easily - I am really happy with it. Read more

I couldn't find the filter locally and finally found it through you on line. It was easily replaced once I had the right filter. Read more

I had a slow leak at the water inlet valve where the water line from the filter assembly connected to the water inlet valve. I determine that the water line had scratches in it which caused it to not seal. Had to buy the entire reservoir and filter assembly to get that water line. The replacement was smooth. It took about 30 minutes to swap out and it fixed the leak. Read more

The little piece that holds crisper drawer on broke off. Every time pull drawer out lid fell off. I ordered left side panel. All I had to do was take drawer out unscrew old part take track off old part put on new part and screw back in. Took 5 minutes very cheap easy repair. Read more

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

Remove the ice bucket remove screws from one side of shaft remove screws from other end of shaft replace moter easy fix Read more

I bought replacement parts Read more

Replaced water valve and ice maker Read more

Replaced the damper control. It took only 10-15 minutes. Since replacement, the clicking noise has stopped. Very happy with the result. However, want to share that there was probably nothing wrong with the original damper other than the original faulty design. The flap opens and closes and believe the clicking noise was the result of plastic against plastic. Noticed the new damper control is exactly the same as the original except that one of the flap sides now has a thick piece of rubbery... Read more

A bit of online research and some component testing narrowed my issue down to either a faulty ice maker or a bad supply valve. Appliance Parts Pros had both of these, at reasonable prices, so I purchased and replaced both items. I recommend watching online videos to get a sense of what to do, and how to go about doing it. The repairs were relatively easy, other than this being a bottom freezer model hence the ice maker was difficult to access: I removed the freezer door (four screws) to get... Read more

Put filter in and turned Read more

Ordered part and replace it Read more

Replacement. Read more

Replaced icemaker tray assembly. The new assembly looks stronger than the original materials. Read more

I located the web site via the internet and contacted the 1-800 number. The service rep was incredibly helpful and personable. After providing her with the model number and parts needed,the process could not have been easier. My replacement parts arrived the next day a perfect match. I highly recommend using this service, first class all the way. Read more

Used U-Tube diagnostic clips to diagnose that most likely problem was a worn Evaporator Fan Motor which is located in the freezer back wall, located in the top third of the unit. I removed 6 hex head screws from the freezer's interior back panel that covers the evaporator coils. The cover is located in the lower 2/3s of the back wall. Removed all shelving. Also removed screws that held in shelf supports on one side of the freezer wall. I then removed the back panel. You may need to... Read more