Jenn-Air Housing Or Cover

Replace your range's rear cover panel if it's cracked, damaged, or missing. This housing panel protects internal components at the back of your range.

Replace your range's control panel cover if it's cracked, broken, or missing. This housing protects internal electronics and maintains your range's appearance.

Replace your range hood's air box assembly housing if the original is cracked, damaged, or missing. This cover component installs in the ventilation system.

This motor housing is the molded support that secures and protects the appliance motor assembly, helping keep the motor aligned and shielded from debris for reliable operation and quieter running. What it does:

• Provides a stable mounting point and alignment for the motor and related components
• Shields the motor from dust, debris and spray that can cause wear or shorts
• Helps reduce vibration and motor noise by keeping the motor restrained
• Can be replaced if cracked, warped, or allowing motor movement that causes noise or rubbing

• Power off and unplug the appliance before starting any repair; if hard-wired, disconnect power at the breaker
• Remove surrounding panels and components as required to access the motor housing; follow OEM service instructions
• Inspect motor fasteners and mounting hardware; reuse only parts explicitly shown in your OEM diagram unless replacements are included

This motor housing secures and protects the appliance motor and helps keep the motor aligned for reliable operation. Replacing a damaged housing restores proper motor positioning and reduces unusual noise or vibration. What it does:

• Supports and locates the motor assembly inside the appliance
• Protects the motor from debris and contact with other components
• Helps reduce motor vibration and related noise when intact
• Keeps motor mounting points stable to prevent misalignment or rubbing

• One motor housing as shown

• Refer to your model's service manual or parts diagram for correct placement and fastener locations
• Disconnect power before starting any repair to avoid electrical shock
• Handle with care to avoid damaging mounting tabs, gaskets, or adjacent wiring
• Inspect and replace worn motor mounting hardware as needed for a secure fit

Replacement housing cover for range hood LED light and switch assembly. Protects internal components. Needed when original is cracked, broken, or missing.