Jenn-Air Touch Pad

Includes the touchpad membrane switch.

Note: This part does not include the control board. It does include the membrane switch (touchpad) along with the panel. 

Color: Stainless Panel w/Black Membrane

This product is a Whirlpool oven control "panel" assembly. This is a genuine OEM product and is sourced directly from Whirlpool. This part is compatible with Whirlpool, Magic Chef, Admiral, and Maytag appliances.

This is a Whirlpool oven touchpad and control panel assembly. Included in this package is the complete touchpad screen and control panel assembly. This component is used to control the heat and other functions of the range. When the touchpad begins to malfunction, certain functions may not engage properly on the oven. These malfunctions may happen intermittently over a long period. The touch panel assembly can become damaged over time due to normal wear and tear. However, the damage could also be caused by a shortage in the appliance. Always use a voltage tester before diagnosing an issue with the oven.This part is intended for installation on the rear portion of the upper area of the cooktop. Typically, the old component can be removed by accessing the screws on the side of the oven. These are usually located near the bottom of the control assembly. There may be screws on the back panel that allow access to the inside of the central console. Once access is gained to the console, remove the control panel by using a nut driver to remove the small screws that fasten it in place. Once this part is separated, installation can begin on the new component. This is a genuine OEM product sourced directly from the manufacturer. This part is made exclusively for Jenn Air ovens. It is sold individually.

This backguard panel replaces the vertical rear trim on a range, restoring appearance and protecting the control area from spills and heat. It returns the unit to factory look and helps keep controls cleaner. What it does:

• Covers the rear control area and conceals wiring and mounting points
• Protects controls and electronics from splashes, grease, and heat
• Restores the stove or range's original finished appearance
• Helps prevent debris from entering openings behind the control assembly

• Remove power to the appliance before beginning work; confirm power is off at the breaker
• Typical install requires removing fasteners and lifting the old backguard off anchor points
• Handle edges carefully — replacement panels can have sharp edges
• If mounting hardware or clips are damaged, replace them with OEM parts for secure fit

This replacement cover is a protective panel that helps shield internal components from dust and debris and restores the appliance's finished appearance. Installing the correct cover keeps parts protected and helps maintain safe, reliable operation. What it does:

• Protects internal electronics and wiring from dust, lint, and incidental contact
• Restores the appliance's exterior finish where the original cover was damaged or removed
• Helps prevent accidental access to moving or energized components
• Can reduce noise by covering openings near motors or fans

• One replacement cover

• Disconnect power to the appliance before beginning any work
• Handle edges carefully to avoid cuts and to prevent damage to the cover finish
• Verify orientation and fastener locations before tightening screws; do not overtighten