Kenmore / Sears Nameplate, Faceplate

This replacement nameplate insert restores the control-panel trim and appearance on compatible Frigidaire appliances. It provides a clean, finished surface around buttons and displays to improve usability and appliance aesthetics. What it does:

• Replaces a cracked, faded, or missing control-panel nameplate for a like-new look
• Restores labeled areas and trim around buttons and touch controls for clearer operation
• Helps protect underlying control components from dirt and wear
• Addresses cosmetic damage and improves resale or staging appearance

• One nameplate insert as shown

• Intended as a direct-fit cosmetic replacement;
• Remove power to the appliance before accessing the control panel to avoid shock or accidentally activating controls
• Handle trim carefully to avoid scratching the finish; use appropriate trim tools to release clips or fasteners
• If adhesive or clips are damaged, replace only with OEM-specified fasteners or adhesive

This replacement nameplate restores the front identification badge and cosmetic finish on the appliance, helping the unit look complete and factory-original again. It's a direct-fit exterior badge used where the original label has worn or fallen off. What it does:

• Replaces a missing, peeled, or faded exterior nameplate to restore the appliance's appearance.
• Serves as the decorative identification badge that mounts to the appliance surface.
• Helps prevent sharp edges or loose fragments from remaining after the old badge is removed.
• Useful when the original nameplate is cracked, scratched, or no longer adheres.

• One replacement nameplate

• High-level, safety-first: always unplug the appliance or disable power at the breaker before starting work near electrical components.
• Remove the old nameplate and any leftover adhesive or debris; clean and dry the mounting surface before installing the new badge.
• Align the new nameplate carefully and press firmly; handle with gloves to avoid fingerprints or cuts from edges.
• If fasteners or adhesive are required, use the OEM-specified method.