We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Burner stuck on high or won't turn off? This burner control switch regulates heat settings. Moderate DIY repair—label wires before swapping.
If one control starts to fail the rest are sure to follow soon - so I replaced all four on our JennAir S160. Looked up the parts on line. Due to my background as an aviation electrician in the Navy and then working as an electrical systems designer for a defense contractor the toughest part was the clean up. Oh Well. Read more
Most orders arrive by Wednesday, November 25
Replaces a cracked, worn, or broken oven door hinge. Installs on the right side, allowing the door to open and close smoothly and securely.
I ordered both hinges (if the nylon roller was bad on the left, it was probably going to go bad on the right side as well). The web site was easy to navigate, order process simple. Hinges arrived quickly. Slide the oven door up and off. unscrew the three screws for the hinge. You need to then pull up with some force (there is a big spring in there), and twist the hinge to get the last bit out. I used a hemostat to hold the spring and keep it from falling back into the hole. removed the... Read more
Regulates gas flow from the supply line to your range burners. Replace if cracked, leaking, or damaged to restore proper fuel control and flame size.
Replaced the regulator with part #AP5802175. Watched the video when purchasing, and it was spot on. Would have taken me about 15-20 minutes if I had access to a vise, to remove one of the fittings. Was able to get it out using two wrenches, but it was not without a bit of elbow grease. The new part went in easily. Turned on valve on regulator, plugged in the power, turned on the gas valve, done. Everything worked fine. Easy job for anyone with just a few tools. Read more
This is a 3000-watt bake element that mounts in the bottom of the oven cavity. It provides the primary heat source for baking and roasting. Replace this element if the oven is not heating properly, food is undercooked, or the element shows visible damage such as cracks, blistering, or burn-through spots.
Replaced the oven heating element Read more
Fix a microwave that runs but won't heat or won't start when door closes. This door switch is a common fix—most DIYers replace it in 15 minutes.
Checked the three door switches; used ohm meter to see if there was resistance or if a switch was bad. 2 out of 3 switches showed resistance with the ohm meter. The last one tested (of course the last one) NO (normally open) did not show resistance; I.e. the ohm meter reading did not change when the switch was depressed. Appliance parts pros was the only company that had the same model number I was looking for (SZW-V16-FD-63). I ordered the relay switch, 2 days later it arrived (regular... Read more
Secures the igniter to the burner assembly in gas ranges and ovens. Replace if stripped, missing, or damaged during igniter replacement or repair.
I was getting really frustrated with our oven. It would preheat to the correct temperature, then slowly lose heat until it was down to about 200 degrees. So it took about two hours to heat a pizza! Finally decided to repair the oven myself, rather than pay $300.00 to have a repair person come out. Ordered the replacement igniter from AppliancePartsPros.com, and it arrived in two days. I followed the instructional video on the AppliancePartsPros.com website, and it was going well until I... Read more
Burner won't turn off or stuck on high heat? This infinite switch controls surface burner temperature settings. DIY-friendly, 30-minute repair.
The problem seemed to be with the switch so I watched a few youtube videos to learn more about how ranges work. After locating the correct replacement switch I ordered it on-line around 10 pm Tuesday night. The new switch arrived Thursday morning at about 10 am and I had my range back up and working like new in less that 30 minutes. The hardest part was figuring out how to remove the slide in panel to access the switch. There were plastic washer/nuts behind each know which I was able to... Read more
Replace cracked, rusted, or chipped trim at the bottom of your range oven door. Installs with screws (sold separately) after removing the door.
Initially, I took it off, sanded it and painted with appliance touch-up. Still didn't look good so I ordered a replacement part and installed. Read more
If your dual burner stays on low and won't turn off, or the small element doesn't heat, this infinite switch may need replacing. DIY-friendly repair.
Replaced the infinite, dual, switch. Very good instructional video for Safety, removal * install. Read more
Burner cap covers the burner head on gas ranges and cooktops. Replace if cracked, chipped, broken, or missing to protect burner and ensure proper heat.
Ordered replacement parts Read more
This is a micro switch that detects whether the microwave door is properly closed and latched. It is part of the safety interlock system that prevents the microwave from operating with the door open. Replace this switch if the microwave does not start when the door is shut, runs with the door open, blows a fuse when the door closes, or stops mid-cycle intermittently.
Knowing the odds of 2 failures occurring at the same exact time was unusually high, I just searched your site for what other broken items might affect these two failures. Came up with next control item upstream and tallied that item failure with percentages of successful repairs, (4 mins.) door safety switch. Since I had to change out the most likely of the 3 and since I was already was going to be into the switch panel I ordered all 3 and swapped them all out to cover my butt, as they were... Read more
Protective panel lining the bottom of your oven cavity. Replace if cracked, warped, or rusted from heat exposure and spills. Provides smooth surface.
I did research on my own prior to ordering. I looked at other sites, but was impressed with the online chatting-this was very helpful! I ordered three items and had difficulty with one rack. I called customer service and received a new rack the next day. This was meaningful to me because we were heading back home in a few days. The rep was very understanding to my situation and helpful. Read more
Replaces cracked, bent, or broken left front burner tube on gas ranges. Delivers gas from valve to burner head. Common wear part needing replacement.
It was a Friday afternoon, of course, I went to my local supply house for the part. I did look it up on your site first to see what I needed and how much I was looking to pay. I got there and "They don't stock those!" I said thank you and went to do more hunting. I ended up at what I found to be the only other parts place in town, and they could've ordered it, for much more than you, I don't mind paying more to get it now but am not going to wait a week to pay more. I said no and came home,... Read more
Oven not heating or baking unevenly? A faulty bake element is often the cause. This bottom heating element is a straightforward DIY fix in 5-10 minutes.
My husband, who was the FIX-IT repair man at our house, passed away in March. When our bake element burned out my son, who is 18 looked at me and I looked at him and we shook our heads! We hunted on the oven till we found the serial number. We googled for GE OVEN repair parts and up popped AppliancePartsPros. We found the element, ordered it, watched the DETAILED VIDEO on how to change it out. The part came the next day. Philip had the old one out and the new one in in less than 10... Read more
Adhesive overlay that covers and labels the control board buttons on your range. Replace when faded, cracked, peeling, or damaged from heat exposure.
Purchased a new over control board and overlay. Installed in five minutes, and everything works great now. Shipping was super fast, and was here within two days. Read more
Indicator light lens covers and protects the burner signal light on your range. Replace when cracked, discolored, or missing. Confirm fit with your model.
Called for a repair tech, he told me what the problem was, I had already checked out the burnt connections,repair was going to be $450-500 range, My wife & I discussed repair or new range,repair won out.I am a retired machine repairman with some elect skills,so looked up parts online ordered them, installed the new control board with the new "decal" , checked out the oven, etc, everything seems good to go. This range is only 6.5 yrs old , they don't seem to make them last as long as the ones I... Read more