Kenmore / Sears Washer Switch

Washer won't spin or agitate? This lid switch assembly detects if the lid is closed. Moderate DIY repair—front panel removal required. Video available.

Washer won't fill with water or overfills? This water level pressure switch monitors tub water levels. Easy DIY repair, typically takes 5-10 minutes.

Washer won't agitate, spin, or drain but fills with water? A faulty lid switch is the likely cause. This safety switch detects lid position. 20-min DIY fix.

Washer won't fill properly or overfills? This water level pressure switch senses water height and signals the control to stop filling at the right level.

If your washer overfills, underfills, or won't advance cycles, the water level pressure switch likely failed. This part senses drum water height.

Washer won't start or stops mid-cycle? A faulty lid switch is often the cause. This safety switch tells your washer the lid is closed. 15-30 minute fix.

Fix a washer that won't start or spin with this lid switch replacement. Common fix for washers that stop mid-cycle. Standard DIY repair in 30 minutes.

Fix a washer that won't start or agitate with this lid switch replacement. Common fix when your washer won't run with the lid closed. Moderate DIY repair.

Fix a washer that won't change water temperature or cycles incorrectly with this water temperature switch. Simple repair restores proper wash cycle control.

Fix a washer that won't change speeds or has non-responsive speed settings with this rotary selector switch. Direct-fit 3-position switch restores control.

Fix a washer that won't select the right water temperature or cycles with cold water only. This temperature switch restores proper cycle control.

This rocker switch replaces a worn or broken on/off control for the appliance, restoring reliable manual control of the affected function. It's the direct-fit switch used where a small rectangular rocker actuator is needed. What it does

• Acts as the user-operated on/off control for the circuit it serves.
• Restores power control when the original switch no longer clicks or stays in position.
• Common symptom: switch feels loose, is stuck, or the circuit does not respond when the switch is operated.
• Uses the same mounting and electrical connections as the original to simplify replacement.

• Disconnect power to the appliance before attempting service to avoid shock.
• Access usually requires removing a control panel or console; keep track of fasteners and wire locations.
• Transfer wires exactly as removed; confirm firm terminal connections.
• Test switch operation and restore power only after reassembly.

Replace a faulty washer cycle switch if your machine won't advance cycles or gets stuck mid-program. This switch controls cycle progression and timing.