Kitchenaid Igniter

A surface ignitor that produces the spark needed to light gas burners on compatible ranges and cooktops. Replaces a worn or failed ignitor to restore reliable ignition and consistent burner lighting. What it does

• Creates the spark at the burner to ignite gas when the control is turned on.
• Commonly used when burners click but fail to light or when a specific burner never ignites.
• Works with the cooktop's ignition system to provide consistent, repeatable sparking.
• Fits into the burner assembly and connects to the appliance's existing wiring and mounting.

• One surface ignitor (quantity: 1)

• Disconnect power to the appliance and shut off the gas supply before starting any service.
• Handle the ignitor by the ceramic/insulated areas; avoid touching the tip with bare hands to prevent contamination or damage.
• Confirm correct fit and secure all wiring connections; test ignition on a safe flame setting after reinstalling.

This surface ignitor is the replacement spark electrode that provides the spark to light a gas cooktop or range burner. Replacing a failed ignitor restores reliable ignition and helps get burners lighting again. What it does:

• Produces the high-voltage spark that ignites gas at the surface burner
• Replaces cracked, glazed, or non-sparking electrodes that prevent ignition
• Addresses symptoms such as no spark, weak or intermittent sparking, or burners that won't light
• Works with standard surface burner assemblies to restore normal ignition

• One surface ignitor (spark electrode)

• Disconnect electrical power and shut off the gas supply before starting work
• Handle the ceramic electrode carefully; avoid touching or striking the ceramic tip
• Ensure all wiring connections are secure and routed clear of heat sources
• After installation, test each burner for proper spark and ignition before returning the appliance to regular use

This is the dual surface burner spark electrode for select gas cooktops/ranges. It generates the spark needed to ignite the burner, helping restore reliable lighting when a burner won't start or only lights intermittently.

• Produces the ignition spark at the burner head
• Helps address burners that won't ignite, click without lighting, or light inconsistently
• Can resolve weak or no spark conditions at the affected burner position(s)
• Restores dependable burner ignition when the original electrode is worn, cracked, or fouled

• Disconnect power and shut off gas supply before servicing
• Allow the cooktop/range to cool fully
• Access typically requires removing grates, burner caps, and top panel
• Handle the ceramic insulator carefully; avoid bending the electrode tips

This surface ignitor is the replacement part that creates the spark to light a cooktop burner, restoring reliable ignition for your gas range so burners light when knobs are turned. What it does:

• Generates the spark needed to ignite a surface burner
• Helps when a burner clicks but fails to light or only lights intermittently
• Addresses ignition problems caused by a cracked, worn or non-sparking ignitor
• Can reduce repeated clicking or delayed ignition

• Turn off the appliance power and shut off the gas supply before beginning service
• Handle the ceramic/porcelain ignitor carefully—it is fragile and can break if dropped
• Verify electrical connector is fully seated and free of corrosion before reassembly

This surface burner igniter is the spark electrode that lights the flame on your gas cooktop or range. Replacing a worn electrode restores reliable ignition at the affected burner for fast, consistent lighting.

• Generates a high-voltage spark at the burner to ignite gas
• Positions and insulates the tip for consistent flame lighting
• Common symptoms: burner won't ignite or no spark at that burner
• Other signs: needs a match to light, intermittent/erratic spark, cracked ceramic

• Disconnect power and shut off gas supply; allow appliance to cool
• Remove burner cap and head to access the electrode; note wire routing and mounting
• Transfer any bracket/clip from the original part if required and set proper gap/position near the burner port
• Restore power and gas, then test ignition at the repaired burner