Kitchenaid Range Burner & Related Parts

Replacement burner cap that fits over the gas burner head to distribute flame evenly. Replace if cracked, chipped, worn, or missing to restore proper appearance.

Surface burner and electrode assembly for gas ranges and cooktops. Replace when burner is cracked, electrode is broken, or ignition spark is inconsistent.

Burner head sits on the burner base to distribute gas evenly through ports. Replace if cracked, warped, clogged, or missing to restore proper flame distribution.

Auxiliary burner head for gas ranges and cooktops. Mounts over the orifice to distribute gas through precision ports. Replace if clogged or damaged.

Replacement surface burner base for gas ranges. Houses the gas outlet and supports the burner cap. Order when your original is cracked or damaged.

This front inner panel is the structural sheet that forms the inside of the appliance's front assembly. Replacing a damaged panel restores proper fit, alignment, and appearance so the front opens, closes, and seals as designed. What it does:

• Forms the inner structural surface of the front assembly
• Provides mounting points for attached hardware and trim
• Helps maintain correct alignment for smooth opening/closing
• Replaces panels that are bent, rusted, or cracked, which can cause rattles, gaps, or poor fit

• One front inner panel

• Disconnect power; shut off water or gas before servicing
• Support the door/drawer/front while removing fasteners to prevent strain or damage
• Handle sharp metal edges; wear cut-resistant gloves and eye protection
• Transfer original screws, clips, insulation, seals, and trim; check alignment before fully tightening

The burner orifice spud meters gas flow to your range's top burner. Replace worn, clogged, or incorrect orifices to restore proper flame output and combustion.

Distributes gas evenly through burner ports on gas cooktops and ranges. Replace if cracked, clogged, or worn to restore uniform flame distribution.

Distributes gas through ports to create an even cooking flame. Replace if cracked, clogged, or worn to restore proper ignition and consistent heat output.

Controls and stabilizes incoming gas supply to burners and oven. Replace if regulator is cracked, leaking, or fails to maintain consistent gas pressure.

Orifice holder aligns and channels gas from the valve to the burner on gas cooktops and ranges. Replace if cracked, damaged, or rusted for stable flame.

Kit contains 4 burner caps

This natural-gas burner orifice spud meters the correct fuel flow for a 15,000-BTU surface burner. Replacing a clogged, damaged, or wrong-size orifice restores proper flame size, cleaner combustion, and reliable cooktop performance. What it does:

• Meters gas through a calibrated opening to the burner head for correct flame height
• Sized for a 15,000-BTU surface burner using natural gas
• Installs in the orifice holder/valve body beneath the burner
• Typical symptoms of a faulty or mismatched orifice: weak/small flames, yellow/sooty flames, uneven heating, delayed ignition, burner won't reach high heat

• 1 natural-gas 15,000-BTU orifice spud

• Shut off gas supply and disconnect power; allow all burners to cool completely
• Remove grates, caps, and burner heads; lift the top or access the orifice holder as required
• Match each orifice to the correct burner location by BTU rating; do not overtighten
• After reassembly, check all connections for leaks with a non-corrosive soap solution and verify proper flame color/size

• For natural gas applications only; use the correct LP/propane orifice when converting fuel types

Color: black. Small size. Measures about 2-1/2 inches in diameter.

Burner orifice spud for gas ranges. Meters gas flow to control flame height. Replace if clogged, damaged, or when converting between natural gas and LP.

Replacement inner burner cap in coal matte black finish. Sits on center of burner head to shape flame. Replaces worn, chipped, or missing caps.