This lid bumper cushions the contact point between a washer lid and the top panel to reduce slamming noise and protect the finish. Replacing a worn or missing bumper restores smooth, quiet lid operation and helps prevent paint damage.
- Provides a soft stop between the lid and top to minimize noise and vibration
- Helps prevent chips, scratches, and rust where the lid meets the cabinet
- Maintains proper lid spacing for a solid, rattle-free close
- Common signs it's needed: missing/flattened bumper, louder closing, rattling, or visible wear at contact points
What's included: 1 lid bumper Install notes:
- Disconnect power before servicing
- Open the lid, remove the old bumper, and clean the mounting area
- Seat the new bumper fully in the mounting location as designed
- Open/close the lid to ensure quiet, secure contact
Do-It-Yourself Stories from Customers like You
Old Maytag washer rust on lid edges Ulf N. • Swampscott , MA • October 05, 2019
Removed lid sanded down all rust spots, taped over the printed instructions on the inside of the lid, washed with alcohol and spray painted with appliance white epoxy paint. Replaced the plastic hinge-balls and one of the lid support/bumper grommet. It was actually easier to install the lid than removing it; used a small amount of grease to hold both balls in place, by holding the lid vertical and placing the left side to the inserted ball and then pushing the right side down. The lid slides...
Read more