Need Help?
Call or text
Control cable connects engine to safety control bar on walk-behind mowers. Replace if cable is frayed, broken, or detached. Installs between handle and engine.
Usually ships within 4 - 14 days
Fix overheating transmission issues with this transaxle cooling fan. Mounts above the pulley to circulate air and prevent heat damage on riding mowers.
Steering shaft connects the steering wheel to the gearbox on riding mowers and lawn tractors. Replace if bent, cracked, or worn for proper steering control.
Thumb wheel assembly for chainsaw chain adjustment system. Replace this plastic and metal control knob if stripped, worn, or broken. Essential for tightening.
Recoil spring for chainsaw starter mechanism. Applies tension to pulley for rope retraction. Replace if worn, rusted, broken, or damaged to restore operation.
Plastic choke lever for gas line trimmers and edgers. Actuates the choke valve to limit airflow during cold starts. Replace if cracked, broken, or damaged.
Wire harness assembly connects ignition module to engine switch on chainsaws. Replace if wires are frayed, damaged, or connections are loose or corroded.
I replaced the ignition module and flywheel. While I had it open, I also replaced the hub starter which was a cause of the pull starter slipping a bit. The flywheel is "pressed" on, but there are numerous videos on the internet on how to quickly and safely remove it using simple hand tools and likewise, how to adjust the clearance between the module and the flywheel. The case screws look like they are "star driver" needy, but my slot is cut in them which will accommodate a medium, #2 flat blade... Read more
Carburetor for hedge trimmers mixes air and fuel before sending to the engine. Replace if cracked, clogged, damaged, or causing flooding issues.
Chain won't stop when brake is engaged? This chain brake kit tightens around the clutch drum to stop the chain immediately on kickback. Moderate install.
Took the side cover off, noticed the chain brake assembly was damaged from the heat. Also after removing the clip securing the clutch drum I couldn't remove it. Had to use my biggest flat head screwdriver to force the drum off. The inner bearing was shot and the outer rim was worn with a lip on the bottom, reason it wouldn't come off the clutch. Because the parts were so worn out disassembly was difficult, but the new parts went on quickly. Soon I was back in business and the saw is working... Read more
Complete gasket set for chainsaws seals engine components during motor service or repair. Replace when servicing engine to prevent fuel leaks. Verify fit.
Ordered plastic tubes, filter, gas cap, new carb. Read more
Blade spindle assembly for riding mower tractors. Mounts to the deck and spins the cutting blades. Replace if cracked, worn, or wobbling for safe operation.
Won't start or stops running? This riding mower ignition switch controls power to the engine. Common fix for no-start issues. Easy DIY replacement.
Mower won't stop or squeals when braking? This brake pad creates friction against the rotor to safely stop your riding mower. Direct replacement part.
Mower won't start with key turn? This ignition switch restores starting function on riding mowers and lawn tractors. Simple repair for most DIYers.
Replacement drive control cable for walk behind lawn mowers. Installs to connect drive mechanism. Replace if snapped, worn, frayed, or damaged.
Handle knob for lawn mowers, snowblowers, and trimmers. Attaches to upper or lower handle adjustment levers. Replace when cracked, broken, or missing.