Range Control Board

Fix oven display not working, keypad unresponsive, or temperature control issues. This electronic control board restores oven functions and heating cycles.

Range not heating or responding to buttons? This control board manages oven timing, temperature settings, and display functions. Moderate DIY repair.

Display blanking out during heating? This electronic control board manages oven functions, timers, and user inputs. Not difficult to replace yourself.

Replace your range control board if the oven won't heat, display is blank, or buttons don't respond. Restores full electronic control functionality.

This relay board assembly routes power to the appliance's compressor and fans so cooling cycles and motor functions run correctly. Replacing a failed relay board restores proper power switching without replacing major components. What it does

• Switches power to compressor and condenser/evaporator fans through relay contacts
• Enables start/run sequences for motors and compressors
• Common symptom: appliance not cooling or cooling inconsistently
• Common symptom: loud clicking, repeated start attempts, or compressor/fans not running
• Works as the electrical switching module tied to the main control/relay system

• Disconnect power before servicing to avoid shock or damage
• Handle the board by edges and avoid ESD-sensitive contact with components
• Verify connector fit and orientation before powering up

If your range display is blank, buttons aren't responding, or oven won't heat, the control board may have failed. Moderately difficult repair.

This right-side generator board is the replacement control board that completes the unit's ignition/control circuit, restoring proper operation and reliable starts. Use it to replace a damaged or non-responsive right-side generator board. What it does:

• Routes ignition/control signals to the right-side components and helps enable proper spark or control functions
• Common symptom: no ignition or intermittent starting on the right side
• Common symptom: erratic or no response from the affected side's controls
• Helps restore normal operation when the original board is cracked, burnt, or electrically damaged

• Disconnect power (and gas, if applicable) before starting any repair
• Handle the board by the edges and avoid static discharge; use ESD precautions if available
• Inspect connectors and wiring for heat or corrosion; replace damaged wiring or connectors

Fix an oven that won't heat, shuts down during cooking, or has a blank display. This control board manages temperature regulation and oven functions.

This electronic control board with overlay manages your range or wall oven's heating and user interface. Replacing a failing control restores accurate temperature regulation, proper bake/broil operation, and a readable display so the appliance responds as it should.

• Regulates oven heat by switching bake/broil circuits based on temperature sensor feedback
• Powers and displays the clock, timer, and status messages
• Interprets keypad/touchpad inputs to run bake, broil, and clean cycles
• Common failure symptoms: dark or flickering display, unresponsive buttons, oven won't start or maintain set temperature, or error codes

• Disconnect power at the breaker before servicing; verify no voltage present
• Use ESD precautions and handle the board by its edges
• Photograph/label wiring; move connectors one at a time to the new board and seat fully
• After installation, run any model-specific checks or calibrations per the service/tech sheet

Fix F10 or F11 error codes, non-heating elements, or unresponsive display with this electronic oven control board. Moderate DIY repair, 30-60 minutes.

Fix an oven that won't heat, displays error codes, or shows no display. This range clock timer control board restores timed cooking features. DIY-friendly.

Fix F10 or F11 error codes with this range electronic oven control board. Restores accurate temperature control and timer functions. Moderate DIY repair.

If your range buttons aren't responding or oven won't heat, the electronic control board may have failed. This part restores full function. DIY repair.