Range / Cooktop / Oven Parts
Genuine Ge part
By: Ge
Part Number: WB31K10266
This 8-inch drip bowl installs under your range burner to catch grease and spills. Replace if yours is rusted, cracked, warped, or heavily stained.
Do-It-Yourself Stories from Customers like You
Needed new burner bowls and elements Bill H. • Clarksville , TN • February 26, 2015
Ordered all the parts
Read more
More
$15.95
- Compare At:
-
$18.82
- You Save:
-
$2.87
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3148953
If your range burner won't adjust temperature or stays on high, the infinite control switch likely failed. Direct plug-in replacement, 15-minute DIY fix.
Do-It-Yourself Stories from Customers like You
Couldn't control the heat on the big burner it intermittently got red hot (and stayed there) Fred S. • Emerald Isle , NC • March 26, 2016
I first diagnosed the problem by replacing the burner control (Infinite switch) with one from a smaller burner (one that I knew worked fine). That seemed to solve the problem. I ordered the correct control for the big burner on Saturday night, it arrived Tuesday and installed it in less than 10 minutes using only a Phillips screwdriver.
Remember to unplug the stove before performing any service. Take this time to clean around and under the stove. (You know it needs it!)
Read more
More
$57.39
- Compare At:
-
$68.29
- You Save:
-
$10.90
Genuine Ge part
By: Ge
Part Number: WB21X5301
Fix oven not reaching set temperature or F2/F3 error codes. This temperature sensor monitors internal heat for accurate cooking. Easy DIY repair.
This part fixes the following symptoms
-
Oven is too hot
-
Won't start
-
Little to no heat when baking
See more...
Do-It-Yourself Stories from Customers like You
Wasn't commng up to temperture put it at 350 would only get up to 250 Michael U. • Dix Hills , NY • April 21, 2014
Spoke to a parts pro and told them of the problem. there were 2 possibilieies from the explanation of what the parts do. onw could have been the Range oven igniter. that wasn't it beaacause the over was lighting fine. by process of illimination it was the Oven Sensor Assembly.
Read more
More
$147.54
- Compare At:
-
$179.02
- You Save:
-
$31.48
Genuine Ge part
By: Ge
Part Number: WB29K10023
Medium burner cap for gas cooktops and ranges. Sits atop the burner head to distribute flame evenly. Replace if cracked, chipped, or worn from use.
Do-It-Yourself Stories from Customers like You
Largest burner taking too long to light up on my ge model jgp933sek1ss Gary D. • Louisville , KY • February 23, 2015
Replacing head burner d solved the problem. The 8 year old original developed a mild warp, replacing it was the solution. GE gas cook top Model JGP933SEK1SS. I replaced the other burner caps for a cosmetic renewal.
Read more
More
$39.43
- Compare At:
-
$46.53
- You Save:
-
$7.10
Genuine Ge part
By: Ge
Part Number: WB44T10009
Oven won't broil or heat from the top? This broil element heats the upper oven cavity. Easy 15-30 minute DIY repair with a screwdriver and video guide.
This part fixes the following symptoms
-
Little to no heat when broiling
See more...
Do-It-Yourself Stories from Customers like You
Bake unit cracked and started glowing and sparking like the sun both elements replaced Steven S. • Somerset , KY • April 21, 2015
Easy fix. Both elements replaced while I was at it, so all new. Figured if one went the other was going to follow.
CIRCUIT BREAKER OFF. Removed the back metal panel with my nut driver for the hex head screws. Note where the panel may slip under tabs for support. Remove slip on electrical connections on upper and lower elements. May need a pliers. (I did not want to just pull the element and the wires into the oven with the element and remove them there, like a technician would do. After 15...
Read more
More
$85.36
- Compare At:
-
$102.43
- You Save:
-
$17.07
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304506545
Oven won't heat or takes too long to ignite? This gas range igniter draws current to light the burner. Straightforward DIY repair in under an hour.
Do-It-Yourself Stories from Customers like You
Oven ignitor failure Andrew B. • Monticello , IL • April 01, 2014
Replaced ignitor. Very simple project.
Read more
More
$81.58
- Compare At:
-
$96.26
- You Save:
-
$14.68
Genuine Ge part
By: Ge
Part Number: WB44K5009
Broiler stopped heating or burned through? This top heating element replacement takes 10-30 minutes with basic tools. Disconnect power, remove brackets, and swap wires.
This part fixes the following symptoms
-
Little to no heat when broiling
-
Element will not heat
See more...
Do-It-Yourself Stories from Customers like You
Broil element burned out Tommie S. • Greensboro , NC • June 12, 2014
Once I received the element within three days, I simply removed the other element by unclipping and unplugging lugs in rear. Placed the new one in clips and connected lugs and all was good!
Read more
More
$74.47
- Compare At:
-
$88.62
- You Save:
-
$14.15
Genuine Ge part
By: Ge
Part Number: WD21X10261
The Interlock Switch is an OEM replacement part for GE electric and gas dryers. This safety component monitors the door closure, preventing operation if the door is not securely closed and latched. The switch measures 2 inches long and 1/2 inch wide.
Symptoms of a faulty interlock switch include:
- Dryer failing to start or running with the door open
- Timer display not illuminated when start button is pressed
- Inability to open the dryer door during operation
- Dryer suddenly stopping mid-cycle before fully drying clothes
Causes relate to the internal component contacting the door frame over 50,000 open/close cycles potentially exposing wiring to wear. Regular cleaning the external switch area prevents dust or lint buildup skewing performance.
This genuine GE switch is compatible with Hotpoint and RCA dryers as well.
Note: Can be used as a dishwasher door switch on specific models. Check your model number for the most accurate results.
Do-It-Yourself Stories from Customers like You
Melted door switch. Christopher K. • Greeneville , TN • February 03, 2024
The full story:
Dishwasher stopped running mid-cycle. When I first began troubleshooting I tried manually advancing the timer knob, and the machine would run. That led me to believe that the actual timer assembly was bad, so I replaced it. The dishwasher ran fine for a day, and then the same problem came back. This time, however, I also had to push in on the door to get it to run. I looked around online, and someone suggested that the door latch wasn't closing tightly enough. I adjusted the...
Read more
More
$37.32
- Compare At:
-
$44.04
- You Save:
-
$6.72
Genuine Ge part
By: Ge
Part Number: WB13T10045
Oven won't heat or igniter not glowing? This range igniter assembly ignites the gas burner to heat your oven. DIY repair typically takes 30 minutes.
This part fixes the following symptoms
-
Gas igniter glows, but will not light
-
Won't start
See more...
Do-It-Yourself Stories from Customers like You
Igniter in my ge oven lasts about 1 year Robert W. • Washington , DC • October 24, 2014
After 5 igniter replacements, I've gotten pretty good at this. Less than 30 minutes start to finish -- including mopping under the range, etc. You need one hex driver for the whole job -- 3/8" I believe.
1. Remove all of the racks and the oven door. Remove the bottom panel inside the oven. Now unscrew the flame cover (4 hex screws), remove, and unscrew the old igniter (2 hex screws).
2. Pull the oven away from the wall. Be careful not to kink the gas line. Unplug the range. Remove...
Read more
More
$120.27
- Compare At:
-
$143.12
- You Save:
-
$22.85
Genuine Ge part
By: Ge
Part Number: WB29K10024
Replacement burner cap for gas cooktops and ranges. Sits atop the burner head to distribute flame evenly. Replace if cracked, chipped, or worn.
Do-It-Yourself Stories from Customers like You
Largest burner taking too long to light up on my ge model jgp933sek1ss Gary D. • Louisville , KY • February 23, 2015
Replacing head burner d solved the problem. The 8 year old original developed a mild warp, replacing it was the solution. GE gas cook top Model JGP933SEK1SS. I replaced the other burner caps for a cosmetic renewal.
Read more
More
$18.70
- Compare At:
-
$22.25
- You Save:
-
$3.55
Genuine Ge part
By: Ge
Part Number: WB30T10074
Burner not heating or intermittently going out? This large surface element restores consistent cooking heat. Simple 5-minute DIY replacement. Video included.
Do-It-Yourself Stories from Customers like You
Large heating element not working Shaun G. • Boulder , MT • September 04, 2015
I wasn't sure if it was the heating element surface, the receptacle or the switch. My wife does some canning so it had some good use. It turned out to be the receptacle. I purchased the element as well thinking it needed replaced anyway. All works now. All three items are/would be easy to change.
Read more
More
$62.61
- Compare At:
-
$75.13
- You Save:
-
$12.52
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10535778
Seals oven door to prevent heat loss and maintain proper cooking temperature. Replace when torn, cracked, or heat escapes around door edges. Confirm fit.
Do-It-Yourself Stories from Customers like You
Seal for door ripped into several pieces Michael J. • Sand Springs , OK • April 28, 2017
Ordered new seal pulled old one off and put new one in its place
Read more
More
$53.21
- Compare At:
-
$63.85
- You Save:
-
$10.64
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304534663
Fix an oven that won't heat or takes too long to preheat. This igniter glows but may be too weak to open the gas valve. DIY repair in under an hour.
Do-It-Yourself Stories from Customers like You
Frigidaire gas oven model fgf366ecc would not light i first noticed things too longer than usual to bake broiler worked but main burner in oven would just glow orange and smell of gas Christine K. • Thief River Falls , MN • August 02, 2017
I have used this site before to fix my dishwasher, so I knew to check here first. I searched other's comments to troubleshoot my problem. Ordered the part and it arrived in only a couple of days. I should insert here that I am a 45 yo female, so if I could do this, anyone can. I watched the video and proceeded to replace the part. For my particular model, I didn't access the part from the back, but instead through the underside by removing the bottom drawer. Total from start to finish...
Read more
More
$78.78
- Compare At:
-
$93.75
- You Save:
-
$14.97
Genuine Ge part
By: Ge
Part Number: WB31T10015
Porcelain drip bowl that sits beneath the 8-inch heating element to catch spills and drips. Replace if cracked, rusted, or discolored for easier cleanup.
Do-It-Yourself Stories from Customers like You
Needed new burner bowls Deborah S. • Auburn , MA • January 25, 2015
Ordered the burner bowls from you (after purchasing some locally that did not fit and were very flimsy). These bowls were very well made and fit perfectly. Heavy construction. Appears they will last a long time. Will order anything for my appliances from you in the future.
Read more
More
$15.74
- Compare At:
-
$18.73
- You Save:
-
$2.99
Genuine Ge part
By: Ge
Part Number: WB31K10265
Chrome drip bowl installs beneath 6-inch coil burners on electric ranges. Catches spills and drips during cooking. Replace when rusted, worn, or stained.
Do-It-Yourself Stories from Customers like You
Needed new burner bowls and elements Bill H. • Clarksville , TN • February 26, 2015
Ordered all the parts
Read more
More
$12.95
- Compare At:
-
$15.41
- You Save:
-
$2.46
Genuine Frigidaire part
By: Frigidaire
Part Number: 316220729
Protective cover for your range control panel with button markings. Replace if cracked, faded, or mounting tabs are broken. Installs over the clock assembly.
Do-It-Yourself Stories from Customers like You
Bake element and broil element did not heat Larry H. • Kansas City , MO • November 25, 2016
I first felt along each heating element (bake and broil) hoping to find a rough or blistered place on them. But they were both smooth with no irregular places. (replacing the elements would have been the easiest and cheapest repair.
Pulled the back off the range (unplugged, of course) - checked wiring. There were no loose connections or burned wiring. I disconnected the elements and checked them with a ohmmeter (VOM) and both had continuity. Discovered that both elements used the same...
Read more
More
$34.75
- Compare At:
-
$41.70
- You Save:
-
$6.95