Range / Cooktop / Oven Switch

Burner won't heat or lacks variable control? This infinite switch restores stepless temperature adjustment to electric range surface burners. Moderate DIY.

This small oven light switch controls power to the oven cavity lamp so you can turn the interior light on and off as needed. It replaces a worn or failed switch to restore reliable oven lighting. What it does:

• Completes or breaks the circuit for the oven interior light when engaged
• Commonly used when the oven light won't turn on, stays off, or works intermittently
• Replaces a failed or sticky switch that prevents the lamp from responding
• Matches OEM function and fits the original switch location when specified for your model

• One oven light switch

• Disconnect power to the appliance before starting any repair
• Access is typically through the oven control console or inner liner; remove panels per your model's service instructions
• Handle wiring and connectors carefully; note connector locations before removing

Range burner not heating properly or stuck on high? This infinite switch controls surface element temperature. Moderate DIY repair for most ranges.

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

Replace a faulty infinite switch if your range burner won't heat, stays on high, or cycles incorrectly. Restores variable temperature control.

If your range burner won't heat, stays on high, or won't turn off, the infinite switch may be faulty. This part controls surface element temperature.

If your range burner won't heat, stays on high, or cycles incorrectly, the infinite switch likely failed. This direct-fit part restores precise heat control.

Fix range display issues, unresponsive controls, or error codes with this control board assembly. Common repair for ranges that won't start or heat properly.

Replace a range infinite switch when a burner won't heat, overheats, or stays on continuously. Controls surface element temperature settings.

This genuine wiring harness connects and routes power and signals between refrigerator components to restore reliable electrical connections and component control. It replaces damaged or worn wiring to stop intermittent faults and loss of function. What it does:

• Carries power and signal between fridge modules and components for normal operation
• Replaces frayed, burned, or broken wires and damaged connector ends
• Helps stop intermittent component failures, no-power conditions, and electrical arcing
• Restores secure plug-and-play connections for affected circuits

• One complete harness assembly as shown

• Disconnect power to the appliance before starting any work
• Follow OEM routing and secure with existing clips; avoid pinching or sharp edges
• Match connector shapes and colors; do not force connectors to fit

Oven won't heat to the right temperature or temperature control unresponsive? This thermostat selector switch restores precise temperature adjustment.

Range burner not heating or stuck on high? This infinite switch controls surface element temperature settings. Common DIY repair for heat control issues.