Range / Cooktop / Oven Switch

This replacement light switch controls the oven/range interior light so you can safely check cooking progress without opening the door. Restores proper on/off function when the original switch fails or becomes intermittent. What it does:

• Replaces the failed oven/range interior light switch to restore on/off control
• Stops flickering or intermittent lighting caused by a worn switch
• Allows the oven light to turn on for safe, clear viewing of food while cooking
• Fits behind the control panel or light housing depending on model

• One replacement light switch

• Turn off power to the appliance at the breaker or unplug before starting
• Remove access panels or control housing to reach the switch; keep track of fasteners
• Disconnect wiring connectors by gently pulling straight off; note wire locations before removal

This is an electrical relay used in ranges and ovens to control power to specific components such as heating elements or fans. It switches circuits on and off in response to signals from the control board. Replace this relay if a burner or oven element fails to heat, heats intermittently, or if the relay is visibly burned or damaged.

If your upper oven won't switch cooking modes or heat settings, the selector switch likely failed. This direct-fit control panel switch restores mode selection.

Replace a faulty range infinite switch if your surface burner won't heat, stays on one temperature, or cycles incorrectly. Moderate DIY repair.

Fix a burner that won't spark or ignite with this cooktop igniter switch. Stops continuous clicking and restores normal ignition. DIY repair in 1 hour.

Replace your range infinite switch if burners won't heat, overheat, or cycle improperly. Direct-fit control switch for smooth temperature regulation.

Range burner won't heat or stays on high? This infinite switch controls surface element temperature settings. Common fix for heat regulation issues.

This is a blower speed switch that controls the fan motor in a range's ventilation system. It allows you to adjust the blower speed to regulate airflow during cooking. Replace this switch if the blower fan does not respond to speed changes, runs only on one setting, or fails to turn on or off.

This is a black rocker switch used to control a function on compatible ranges/cooktops. Replacing a worn or inoperative switch restores positive on/off control and reliable operation of the connected feature.

• Controls an appliance function (such as a light or igniter circuit) with a single on/off action
• Common failure signs: switch won't stay on, no response when toggled, intermittent operation, or physical damage/discoloration
• Direct-fit replacement designed for the original switch location
• Helps restore safe, predictable control to the appliance

• Disconnect power and, if applicable, shut off gas before servicing
• Access is typically from the control panel; retain orientation of wires and note terminal positions
• Transfer wires one at a time to the new switch to avoid miswiring
• Inspect connectors for heat damage; replace damaged terminals before reassembly

This burner box wiring harness connects the cooktop/oven burner components to the appliance's control systems, restoring reliable ignition and power routing for the burner box area. Use to replace a damaged or burnt harness for safer operation. What it does

• Routes electrical connections between igniters, sensors, switches, and control modules in the burner box
• Restores ignition or heating when a frayed or open harness prevents burners from sparking or heating
• Replaces harnesses with cracked insulation or melted connectors that can cause intermittent operation or arcing
• Helps eliminate electrical shorts and poor contact at connector plugs inside the burner box

• One burner box wiring harness as shown

• Disconnect all power (electrical and gas) before servicing; verify power is off
• Inspect connectors and routing in the burner box, replacing any mounting clips or fasteners if damaged
• Ensure correct connector seating and secure wiring away from high-heat components