Refrigerator Ice Maker & Related

I replaced the 2 metal parts that were rusted out. Read more

I ordered the complete assembly ice bucket and all Read more

My fridge was too cold - everything was freezing solid, even in the produce bins. The air from the diffuser vent was constantly running. After unplugging the fridge and plugging it back in, the diagnostic code on the control panel indicated that the air diffuser was not working. I purchased a new air diffuser, watched the very helpful video that showed how to install it, and replaced the part in about 10 minutes. The next day, I can tell that everything in my fridge has finally begun to thaw... Read more

Replaced the bin and drive shaft. The video was really helpful. Ordered the parts they fit and it was a breeze. Read more

Replaced ice bin assy. Read more

Had to replace the auger. The auger on my ice maker was made of plastic and had broken pieces off it. The new one is made of metal and seems to work much better. Was a fairly simple repair. However pay close attention when disassembling, I recommend using your cell phone and snap a pic of the different stages as I became a little confused when putting it back together. Ordered the part and it was here the next day. I'm very happy to have my ice coming down the chute again. By the way, I'm a 70... Read more

I ordered a complete new bin with everything in it attached already. All I had to do was wash it and set it in the compartment on freezer door. Within a couple hours, I had ice again. Easy fix. Read more

• Ice maker not making ice
• Ice maker won't dispense ice

Replaced both parts Read more

• Ice maker won't dispense ice

Removed old cap replace with new 5 min. works like new received new part in 2 days Read more

• Ice maker won't dispense ice

Replaced the parts. Initially, in order to ensure the ice maker itself was still working, I did some repairs to test it. I repaired the cracked crusher cover with a plastic welder, I also repaired the glide bucket Lh with the plastic welder & some epoxy. I attached the broken ice stripper pieces with the plastic welder. If the ice maker made ice I knew it was safe to buy new parts. It made ice for two days only but after it dropped ice the first time I ordered the parts. Parts did not... Read more

My problem started with a rusting condition in the ice bin that spiraled out of hand. I took apart the ice bin and all the hardware thinking I could clean it with the suggested baking powder. Plastic parts cleaned up like new, metal parts were pitted. I wire brushed and sanded the parts put it all back together and gave it a try. All appeared fine then two days later the ice dispenser stopped. I watched a couple of videos and most pointed to the ice auger motor. One video specifically said you... Read more

Purchased Appliance Parts Pros replacement ice maker, removed the defective unit, matched the proper wiring harness using the wiring color codes at the P and J side connectors. Approximately 1 hour following the installation, I delightfully heard the first set of cubes ! Read more

I found a video/tutorial on how to take it apart to see what was pieces were broken, then ordered the replacement parts and watched the video to put it back together again. Read more