Wall Oven Parts

• Oven is too hot
• Little to no heat when baking
• Won't start
• Oven not heating evenly

Online videos made this seem an easy fix. I unplugged the oven and removed the rear panel, then found where the temp sensor entered the oven. I unplugged the sensor's electric connector. Unlike the videos, this sensor screwed in from the inside of the oven, so I had to remove the 2 screws inside the oven which hold the sensor in place. Then I pulled the sensor out, careful not to tear the insulation with the wires and connector. Then I just pushed the new connector through the same hole and... Read more

The first symptom was our microwave would continue to run after the time was up. The light would go out, the turn table would stop but you could still hear the microwave running and whatever was in it would continue to cook. The only way to stop it was to open the door. It was intermittent at first but eventually it would always run no matter what as long as the door was closed. Several other posts referenced these switches as the problem. I just replaced both and problem gone. It turns out... Read more

Burners were an exact match for the originals and the pans fit perfectly. Vastly improved the appearance of an old cook top and allowed us to to not have to replace it before our home goes up for sale. Read more

• Little to no heat when broiling

Ordered a new part. Watched a YouTube video. Fixed it in 15 minutes. Knowing you need to stop the connectors from slipping into the back of the oven was the key. I used paperclips to stop the wires falling through the hole. Easy as ... Read more

Replaced the oven controller. This needed the only removal of six hex screws securing the back guard rear shield, two-wire plugs on the control unit, and four Phillips screws. All are easily accessible. The only difficulty came from an apparent model design change that separated the control unit and the overlay - the labels for the control buttons (items 20 and 20a in the backyard parts diagram). Mine is a single unit (the overlay could not be removed without damage) led to the assumption that... Read more

• Oven is too hot

Well it wasn't hard to replace at all pretty easy. But trying to figure out what the problem was that got me. I turned of my oven and the light continued to stay on like it wasn't turn off but it was. I researched it and said it was the oven elements not true I was already confused enough so I said let go to the source of what make oven come on the oven control knob so I took the old switch off and looked up the numbers and ordered the part and lucky me that was the problem less than 50$ to fix... Read more

• Won't start
• No heat
• not self-cleaning

Did some Google searches and most comments concerning this issue on LG stoves indicated the high temperature thermostat malfunctions when using the self cleaning function. This malfunction causes complete loss of power for the entire stove and locks the oven door. Since I wasn't completely sure if it was the thermostat or where it was for that matter, I called a service tech to troubleshoot the stove. He was able to determine it was the thermostat and further tested his findings by... Read more

I first checked the power , we had 220 volt at plug, I removed the back of the stove, checked things out , I found that the stove top burners still worked and the oven light worked. I tested and found that we had current to the timer and clock but nothing on the control worked to set the time, or to turn the oven on or to set the oven temp. I ordered this part on June 30th and received the next morning. I disconnected stove from electrical plug. Be Sure to unplug the stove for your... Read more

I knew for sure that the hinge with the large spring was damaged, but elected to replace both hinges and receivers. Replacing the parts was fairly easy and would have taken me less then an hour. This model has thin metal covers over the hinge assemblies. I found that squeezing in the sides of the covers help to hold them in place on the hinge while reassembling the door. My only difficulty was putting the door back on the oven. It took a little maneuvering but I managed to get it. Now the door... Read more

I had to take the top panels off and two back panels off. Took off about thirty screws. It was very dirty and dusty inside so I took the lower panels off as well to clean and vacuum it. The hardest part was getting the double oven out of the cabinet. Overall it was very doable. Read more

Ordered New Gasket and installed in about 3-4 Minutes. Only need small pliers to remove some of old clips from holes. New Gasket clipped in easily by hand. Read more

Replaced the rotary switch and fixed my problem. Read more

After researching the problem, I ordered a new cooling fan. My "fix-it" guy winds up in the ICU for 3 weeks! So...YouTube here I come. It appeared pretty simple in video form, except the video wasn't of my stove. All in all, what looked like no more than a 6 screw removal, turned into tearing 1/2 the stove apart. Still, only took about 2 hours start to finish. Best lesson learned, turn off the energy efficiency mode!!! Read more

Replaced the blown heating element. I also only to be on the safe side, replaced the over temp sensor. I checked it with the meter when I pulled it out and it was ok. Tested ok. Thank you very much for the less than 2 day delivery on the part. Read more

Diagnosed the problem by seeing the lower fan was not turning. Didn't have any squeaks or sounds as a warning sign... It just stopped working. Went to AppliancePartsPros.com typed in my make & model number (Samsung NE58F9710WS). The web site pulled up the parts schematic, I navigated to the part on the schematic (Assembly #8 - Assy Motor Convection-Re DG96-00110B / AP5580897) and ordered it "Express Shipping" because I need the oven for Thanksgiving. When the part arrived, it looked identical... Read more

I read on line about other such ovens doing the same thing mine was doing, absolutely nothing! I even read stories of a major retailer telling customers to throw the microwave away. There's nothing you can do to fix it. After replacing a simple fuse that I ordered from you, the Advantium is as good as new. It took a grand total of 5 minutes to make the repair. The shipping cost more than the part, but it was all very worthwhile. Read more