Whirlpool Fuse Or Sensor

This high-limit thermostat helps stop overheating by opening the heater circuit at preset temperatures, protecting the appliance and improving safety. Replace a failed thermostat to restore proper over-temperature shutoff. What it does:

• Opens the heating circuit at its rated temperature to prevent excessive heat buildup
• Stops the heater from running if the appliance overheats
• Common symptoms: appliance overheating, no heating or intermittent heating, or heat cycling off unexpectedly
• Used as a safety cutoff in the appliance's heating system

• Disconnect power before inspecting or replacing the thermostat
• Handle terminals carefully and note wiring locations for correct reassembly
• Verify operation only after proper installation and restoring power

This fixed thermostat senses temperature and opens or closes the electrical circuit to control heating. It replaces a failed temperature-sensing switch to restore proper heating control and safety. What it does:

• Monitors appliance temperature and interrupts power when the set limit is reached
• Prevents overheating by opening the circuit at high temperatures
• Restores normal heating control when a failed thermostat causes no heat or continuous heating
• Works as a safety/limit device in the appliance's heating system

• Disconnect power to the appliance before starting any repair
• Handle the thermostat and sensing element gently; avoid bending or stressing terminals
• Refer to the appliance service manual or OEM instructions for proper placement and mounting

The thermal cutoff is an OEM part for Whirlpool dryers. This thermal cutoff plays an important safety role by automatically shutting off power to the dryer's heating element in the event of excessive temperatures.

The thermal cutoff is responsible for monitoring air temperatures inside the dryer drum and air ducts. As temperatures rise past safe levels, the thermal cutoff triggers, cutting power to prevent damage and possible fire hazards.

Causes of a bad thermal cutoff can include overheating from issues such as a clogged or blocked vent hose, venting into an unvented space, an accumulation of lint, or a failing vent switch.

Symptoms of a bad thermal cutoff include:

• The dryer not heating up or heating unevenly
• Repeatedly tripping the circuit breaker during operation
• Scorching or burning odors detected from the dryer drum or vent

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This genuine replacement sensor monitors operating conditions in your appliance and restores accurate readings so controls can regulate cycles and performance. It's a direct-replacement sensing element used by the control system. What it does:

• Detects operating condition changes (temperature/level/position depending on application) so the control board can adjust cycles
• Helps eliminate cycle problems caused by faulty or intermittent sensor readings
• Commonly associated with symptoms like incorrect cycle behavior, error codes related to sensing, or inconsistent performance
• Works as the factory-designed sensing input for the appliance control system

• One sensor/sensing element as shown

• Disconnect power to the appliance before attempting service to avoid shock or injury
• Handle the sensor and connector carefully to avoid damage to terminals or wiring
• Reconnect wiring exactly as removed; ensure secure connector seating before testing

This high-limit thermostat (hi-limit switch) is a temperature safety device that stops the heating circuit if the appliance overheats, helping protect the unit and restore proper heat control when replaced. What it does:

• Opens the heating circuit if internal temperature exceeds safe limits to prevent overheating.
• Controls whether the heater/element receives power based on temperature.
• When faulty, common symptoms include no heat or intermittent heating and repeated thermal cutouts.
• Can be tested for continuity to confirm electrical function.

• One high-limit thermostat (hi-limit switch).

• Disconnect power before inspecting or replacing; risk of shock or injury if energized.
• Note and label wire locations or take a photo before removal for correct reassembly.
• Verify part compatibility with your model before installing; confirm continuity after installation.