Whirlpool Motor

This evaporator fan motor drives the freezer fan that circulates cold air across the evaporator coils and through the ducts. Replacing a weak or noisy motor restores proper airflow for consistent cooling and defrost performance.

• Circulates cold air from the evaporator through the freezer and fresh food compartments
• Helps maintain even temperatures and quicker recovery after door openings
• Common failure symptoms: warm refrigerator section, little/no airflow from vents, loud humming/squealing or intermittent fan operation, and frost/ice buildup on the freezer's rear panel
• Also known as the freezer fan motor or "Motor-Evap"

• Disconnect power; remove shelves/drawers and the rear interior freezer panel to access the fan
• Note wiring and mounting orientation; unplug connectors and remove the old motor
• Transfer the fan blade and any rubber isolators/mounting hardware from the original motor if needed
• Ensure blade orientation and wire routing clear the blades; test operation before reassembly

The Blower Motor is an OEM part for Whirlpool ranges. It is an electronic component located underneath the range that is responsible for removing heat, smoke, and odors from the kitchen. The down draft blower motor operates an exhaust system that draws air through a vent behind the cooking surface and vents it outside.

Causes of a bad down draft blower motor can include normal wear and tear over time, exposure to grease or debris which can cause clogs or mechanical issues.

Symptoms of a faulty down draft blower motor include:

• Inadequate ventilation of heat, smoke or odors from cooking
• Slow or delayed venting of the cooking area
• Loud buzzing or grinding noises coming from underneath the range
• Failure of the venting system to turn on

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Ice box Fan is an OEM part for Whirlpool refrigerators. Located inside the freezer compartment, it circulates cold air to the ice maker compartment.

Causes of a bad icebox fan include failure of the motor from continuous operation, or damage to fan blades.  

Symptoms of a bad icebox fan involve:

• Clicking or grinding noises emanating from inside walls
• Ice compartment not cool enough
• Ice melting
• No ice being made

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This 1/4 HP motor assembly replaces a worn drive motor to restore proper drive power and rotation. It's a direct-fit mechanical motor intended to bring moving components back to OEM performance and reliable operation. What it does

• Provides drive power for the appliance's rotating components to restore normal operation.
• Replaces a failed or noisy motor that causes little or no rotation, intermittent operation, or a humming/stalling condition.
• Helps eliminate abnormal motor noise, vibration, or overheating when the motor is the root cause.
• Restores consistent mechanical speed and torque for components that rely on the motor to function.

• One 1/4 HP motor assembly

• Disconnect power before servicing; follow all safety precautions.
• Verify mounting orientation, shaft alignment, and proper belt/drive configuration during reassembly.
• Inspect and replace worn belts, pulleys, or mounting hardware as needed to prevent repeat failures.

This drive motor has been manufactured by Whirlpool and is intended to replace a worn or faulty part in dryers.The drive motor enables the dryer to work as intended because it rotates the drive belt, which in turn spins the drum. Without a working motor, the drum won't rotate efficiently or at all and the materials and clothes will not be dried properly. Thus, a broken drive motor should be immediately replaced. To ensure safety when working on this appliance, make sure it has been entirely disconnected from the power source and work gloves are worn to prevent injuries from occurring.This is a genuine OEM part sourced from the manufacturer and is compatible with various dryers that have been made by Whirlpool, Maytag, Amana, and other brands. This part has been manufactured from high-quality, durable, non-corrosive materials to ensure the best possible quality and is only sold individually.

This Is A Blower Motor !!!! For Turntable Motor Use W10642989!!!!

This evaporator fan motor assembly circulates cold air across the evaporator coils to maintain even refrigerator/freezer temperatures. Replaces a worn or noisy fan to restore proper airflow and cooling performance. What it does:

• Moves air across the evaporator coils to help the appliance cool efficiently
• Helps reduce frost buildup by maintaining steady airflow over coils
• Commonly replaced for symptoms like loud fan noise, weak airflow, or uneven cooling
• Designed as a motor with attached scroll-style fan (impeller) for direct fit operation

• Disconnect power to the appliance before beginning any service to avoid electrical shock
• Handle the fan blades carefully to avoid bending or damage that can cause vibration
• Some installations require removing interior panels or the evaporator cover; keep track of screws and clips
• If the connector or mounting hardware appears damaged, replace with OEM-equivalent parts for safe operation

This stator is the stationary motor component that creates the magnetic field needed for the washer's drive motor to operate. It restores motor function so the appliance can agitate and spin normally. What it does:

• Generates the magnetic field that interacts with the rotor to drive the motor.
• Enables proper agitation and spinning when the motor and rotor are functioning.
• Commonly replaced when motor runs poorly, makes unusual noises, or the washer fails to spin.
• Works as part of the motor assembly to maintain consistent motor performance.

• One stator

• Disconnect power and water supply before beginning any repair.
• Access typically requires removing the washer cabinet or motor housing; follow the service manual for your model.
• Inspect the rotor/motor and wiring for damage when replacing the stator.

This motor capacitor helps the appliance motor start and run smoothly by providing the electrical phase shift needed for motor operation. Replace a failing capacitor to restore reliable motor starting and consistent performance. What it does:

• Provides the electrical charge that helps the motor start and maintain rotation
• Commonly replaced when the motor hesitates to start or runs weakly
• Can prevent excessive motor strain and reduce occasional stalling or intermittent operation
• Related to symptoms such as humming from the motor, slow or no start, or irregular motor performance

• Disconnect power to the appliance before servicing to avoid shock hazard
• Capacitors can hold charge—discharge safely before touching terminals
• Inspect mounting and wiring; replace with the exact specified capacitor for the appliance

The Motor Rotor is an OEM part for Whirlpool electric top-loading washers. Located internally at the center of the washer basket, it transmits power from the motor to spin water from clothes during extraction cycles.  

Symptoms of a faulty motor rotor include: 

• Slow or inefficient spin that leaves clothes dripping wet   
• Abnormal vibrations felt from the tub during spin
• Premature winding motor sounds due to rotor imbalance

Causes involve normal wear from years of moving wet laundry loads. Damage could also occur from objects left in pockets that damaged the rotor during spin.

This OEM replacement is compatible with additional Whirlpool, Kenmore, and Maytag top-loading washers.

This evaporator fan motor drives the fan that circulates chilled air across the evaporator coils and through the cabinet, helping maintain even, stable temperatures and consistent cooling performance.

• Moves air across the evaporator coils and through the vents for uniform cooling
• Helps the refrigerator recover temperature after door openings
• Common symptoms of a failing motor: fresh food section warmer than the freezer, little or no airflow from vents, fan not running with the door switch pressed, or loud/abnormal fan noise
• Supports overall system efficiency by keeping air moving around stored items

• Disconnect power to the appliance before servicing
• Transfer and reuse the original fan blade, bracket, grommets, and screws if your model uses them
• Clear any frost or obstructions from the fan shroud and surrounding area before reassembly
• After reassembly, restore power and press the door switch to confirm the fan runs and airflow is present

The Condenser Fan Motor is an OEM part for Whirlpool brand bottom-mount refrigerators. This motor powers the condenser fan which dissipates heat from the refrigeration system coils, maintaining cool interior temperatures.

Causes of failure include normal bearing wear from continuous rotations, or buildup obstructing free blade movement. 

Symptoms of a faulty motor include:  

• Elevated interior temperatures and frost propagation issues   
• Extended run times and higher energy consumption
• Grinding or buzzing noises emanating from the refrigeration system area

This Whirlpool replacement restores efficient heat removal and preserves food freshness. Compatible with KitchenAid, Maytag, and some Kenmore models too, it prevents future repair bills.
 

The convection fan is an OEM component for Whirlpool ranges. It functions as the convection fan system, circulating hot air within the oven cavity to provide efficient all-around heating. 

The convection fan is responsible for proper air circulation and temperature distribution during convection bake and roast cycles. It allows for fast, even cooking on multiple racks simultaneously.

Symptoms of a bad convection fan include:

• Inefficient or uneven baking/cooking results  
• Longer than normal cook times
• Overheating or hot spots within the oven
• Strange noises coming from the convection fan area

Causes can include a failed motor, worn fan blades, or blockages that disrupt airflow.

This Whirlpool OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore ranges.

This stator is the stationary motor assembly that creates the magnetic field to drive the washer motor. It restores proper motor function so the washer can agitate and spin reliably when the rotor and drive are working. What it does:

• Generates the magnetic field needed for the washer motor to turn the rotor and tub
• Replaces a worn or damaged stator that can cause humming, no-spin, no-agitate, or intermittent motor operation
• Works with the rotor and motor assembly to deliver consistent torque during wash and spin cycles
• Designed to fit the original motor housing and align with factory mounting points

• One stator assembly

• High-level replacement only; motor disassembly is required—refer to manufacturer instructions or a service manual
• Disconnect power before servicing to avoid shock or injury
• Inspect rotor, bearings, and wiring while motor is accessible; replace any damaged components